Experimental Investigation on Film Cooling of Gas Turbine Cascade
نویسندگان
چکیده
منابع مشابه
Simulation of Mist Film Cooling on Rotating Gas Turbine Blades
Film cooling technique has been successfully applied to gas turbine blades to prevent it from the hot flue gas. However, a continuous demand of increasing the turbine inlet temperature to raise the efficiency of the turbine requires continuous improvement in film cooling effectiveness. The concept of injecting mist (tiny water droplets) into the cooling fluid has been proven under laboratory co...
متن کاملSimulation of Mist Film Cooling at Gas Turbine Operating Conditions
Air film cooling has been successfully used to cool gas turbine hot sections for the last half century. A promising technology is proposed to enhance air film cooling with water mist injection. Numerical simulations have shown that injecting a small amount of water droplets into the cooling air improves film-cooling performance significantly. However, previous studies were conducted at conditio...
متن کاملAn Investigation of Mist/Air Film Cooling with Application to Gas Turbine Airfoils
................................................................................................................................. v Chapter
متن کاملAn Innovation in Film Cooling of the Gas Turbine Blades Applying an Upstream Jet
A new design concept is introduced to control the near-wall integration between the hot-gas boundary layer and the cooling jets in order to enhance the adiabatic film cooling effectiveness of the gas turbine blades. In this new approach, another film cooling port, having a very low blowing ratio, which prevents formation of the counter-rotating vortex pare, is applied just upstream of the main ...
متن کاملExperimental Investigation into the Hydrodynamics Effects of Slot Film Cooling on a Cylindrical Model
An experimental study of hydrodynamics of film cooling is performed by using a single longitudinal slot on a cylindrical model simulated to the leading edge of the gas turbine blade. The model is set up into the test section of an open-circuit induced flow wind tunnel which provides the main flow. The injected air, as a secondary film flow, produced from a high pressure compressor is considered...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1984
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.50.1761