Experimental investigation of solidification in metal foam enhanced phase change material
نویسندگان
چکیده
منابع مشابه
experimental investigation of temperature gradient in a greenhouse bed soil containing phase change material
0
متن کاملExperimental investigation on the effect of phase change materils (PCM) in solar compression refrigeration cycle efficiency
Saving energy is one of the most important challenges of todaychr('39')s world. Reducing electrical energy consumption in compressed air systems is one of the essential requirements for designing these systems. When using domestic air conditioners (dual air conditioners) in very hot areas (Khuzestan) their performance decreases and electric current consumption increases. Therefore, the use of n...
متن کاملNumerical and Experimental Investigation of Solidification Shrinkage
The solidification heat transfer, melt convection and volume shrinkage in the casting of an energetic material are analyzed through numerical modeling and experimental investigation. The shrinkage resulting from phase change is considered through the volume of fluid method. The model is validated against an analytical solution and then applied to study the volume contraction during the casting ...
متن کاملExperimental Investigation on the Effect of Partially Metal Foam inside the Absorber of Parabolic Trough Solar Collector
In the present work the efficiency of a solar parabolic trough has been investigated experimentality. parabolic trough solar collector constitute a proven source of thermal energy for industrial process heat and power genaration. The impact of using the partially porous media in the absorber on the efficiency of PTC (parabolic trough collector) has been investigated. The porosity of copper foa...
متن کاملExperimental Investigation of Sinusoidal Tube in Triplex-Tube Heat Exchanger during Charging and Discharging Processes Using Phase Change Materials
In this experiment effect of two full and half width sinusoidal inner tubes in triplex-tube heat exchanger with phase change material (PCM) was investigated. Length and diameter of the tubes have been chosen such that the area of each tube to be the same. Charging and discharging processes were carried out by inner tube, outer tube and both. Results indicated, PCM melting and solidification tim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2017
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/251/1/012112