Experimental Investigation of Friction Stir Welding on 6061-T6 Aluminum Alloy using Taguchi-Based GRA
نویسندگان
چکیده
منابع مشابه
Feasibility study of friction stir welding of 6061-T6 aluminium alloy with AISI 1018 steel
The present work demonstrates that friction stir welding (FSW) is a feasible route for joining 6061 aluminium (Al) alloy to AISI 1018 steel. The weld has a good weld quality and is free of cracks and porosity. The tensile failure happened at the boundary between the nugget and thermomechanically affected zone of the base Al alloy, indicating that the weld has a higher joining strength. Despite ...
متن کاملTwo-dimensional Mapping of Residual Strains in 6061-t6 Aluminum Alloy Friction Stir Welds
The residual strain profiles were measured through the thickness of friction-stir welded (FSW) plates using neutron diffraction to study the relationship between the angular distortion and the residual strain distribution. Three different weld specimens were prepared from a 6061-T6 aluminum alloy with the purpose of separating the effects of the frictional heat and plastic deformation on the re...
متن کاملAnalysis and Comparison of Friction Stir Welding and Laser Assisted Friction Stir Welding of Aluminum Alloy
Friction Stir Welding (FSW) is a solid-state joining process; i.e., no melting occurs. The welding process is promoted by the rotation and translation of an axis-symmetric non-consumable tool along the weld centerline. Thus, the FSW process is performed at much lower temperatures than conventional fusion welding, nevertheless it has some disadvantages. Laser Assisted Friction Stir Welding (LAFS...
متن کاملWelding Parameter Optimization of Alloy Material by Friction Stir Welding using Taguchi Approach
Friction stir welding is used as a solid state joining process for soft materials such as aluminium alloys and also for hard materials like steels. It avoids many of the common problems obtained in fusion welding. In mechanical, civil, automobile, naval, and aeronautical engineering beams are widely used of the magnesium alloys for different applications and that are joined by conventional iner...
متن کاملModeling and optimization of end milling parameters on aluminum 6061 alloy using GRA based Taguchi method coupled with PCA
Quality and productivity are two important aspects for manufacturing industries. Modeling and optimization is the best technique applied to find the best manufacturing conditions. This technique has been applied to investigate the optimized design of the cutting process in end milling for Al 6061 alloy in order to provide better surface finish as well as high Material Removal Rate (MRR). The cu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals
سال: 2020
ISSN: 2075-4701
DOI: 10.3390/met10111480