Experimental estimation heat flux and heat transfer coefficient by using inverse methods

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Inverse Estimation of Boundary Heat Flux for Heat Conduction Model

Mathematical model of direct and inverse problems is developed for the flat plate probe which is subjected to timedependent heat flux at one end, while the other end is kept insulated. The direct solution, which is concerned with determination of the temperature distribution in the probe, is developed using an approach based on the method of variation of parameters. The direct solution is used ...

متن کامل

Optimal Sensor Spacing in Experimental Determination of Heat Transfer Coefficient by Inverse Analysis

It is shown that there exists an optimal spacing of thermo-sensors in the determination of the experimental heat transfer coefficient of a fluid flowing over a plate. The problem is considered as an inverse heat transfer problem with long thin fin model. The heat transfer coefficient of the fluid is estimated from simulated steady-state temperature measurements along the plate. It is shown theo...

متن کامل

Experimental study of convective heat transfer coefficient of MgO nanofluid in a cylindrical microchannel heat sink

Convective heat transfer of MgO-water nanofluid in a microchannel heat sink is experimentally investigated in various concentrations of 0.01, 0.05, 0.1, and 0.6 wt%. The microchannel consisted of 48 parallel rectangular cross section channels with the height of 800 µm, width of 524 µm and length of 52 mm. A well stability duration (ca. 1 month) was resulted by a 180 min ultra-sonication of the ...

متن کامل

A TRANSIENT TWO-DIMENTIONAL INVERSE ESTIMATION OF THE METAL-MOLD HEAT TRANSFER COEFFICIENT DURING SQUEEZE CASTING of AL-4.5WT%CU

In this paper, a transient, two-dimensional and nonlinear inverse heat conduction problem in solidification process is considered. Genetic algorithm is applied for the identification of the interfacial heat transfer coefficients during squeeze casting of commercial aluminum alloy (Al-4.5wt%Cu) by assuming a priori information regarding the functional form of the unknown heat transfer coefficien...

متن کامل

Analysis of Flux-Base Fins for Estimation of Heat Transfer Coefficient

Exact solutions are given for the transient temperature in flux-base fins with the method of Green’s functions (GF) in the form of infinite series for three different tip conditions. The speed of convergence is improved by replacing the steady part by a closed-form steady solution. For the insulated-tip case, a quasi-steady solution is presented. Numerical values are presented and the condition...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Scientia Iranica

سال: 2016

ISSN: 2345-3605

DOI: 10.24200/sci.2016.3925