Experimental and simulatedd pbreakup reaction data at 300, 400 and 500 MeV
نویسندگان
چکیده
منابع مشابه
REACTION AT 198 MeV
The reaction 45Sc(n, P)45Ca has been studied at an energy of 198 MeV with energy resolution of about 1 MeV. Measurements were carried out at nominal angles 0°, 3°, 6®, 9®, 12°, 15°, 18" and spectra obtained up to -40 MeV excitation energy in 45Ca . Significant Gamow-Teller strength is observed at an excitation energy of about 7 MeV, somewhat higher than predicted by shell-model calculations . T...
متن کاملDose equivalent from 500 MeV neutrons
Neutrons constitute a major component in the radiation fi eld outside the shielding of particle accelerators. Consequently appropriate neutron dose meters are needed to survey the radiation levels. A thermo-luminescence based neutron dosemeter is used at the UNILAC as well as at the SIS. It has been modifi ed to improve the response for high energetic neutrons (extended range). We report on a t...
متن کاملSliding Wear of TiN coated 321 stainless steel in CO2 at 300 and 500°C
Advanced carbon dioxide-cooled nuclear reactor environments can be tribologically hostile, with steel components sliding in contact at high temperatures. Although wearprotective oxides can reduce damage in the steady-state conditions, severe wear can occur in the early stages, particularly at temperatures of 300 to 500 "C, where oxidation rates may be low. In this paper, results are presented o...
متن کاملCreep resistance of cast and aged Al–0.1Zr and Al–0.1Zr–0.1Ti (at.%) alloys at 300–400 C
Cast and aged Al–0.1Zr and Al–0.1Zr–0.1Ti (at.%) alloys, upon compressive creep deformation at 300–400 C, exhibit threshold stresses attributable to climb-controlled bypass of coherent Al3Zr and Al3(Zr1 xTix) precipitates. Al–0.1Zr–0.1Ti exhibits a smaller threshold stress than Al–0.1Zr, which is attributed principally to a reduced lattice parameter mismatch between the Al3(Zr1 xTix) precipitat...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: EPJ Web of Conferences
سال: 2014
ISSN: 2100-014X
DOI: 10.1051/epjconf/20148106005