Experimental and Analytical Investigations of Fracture Toughness in Weldments of 6082 Al Alloy
نویسندگان
چکیده
منابع مشابه
Development of microstructure and fracture toughness of AL-6063 alloy using equal channel angular extrusion
Severe plastic deformation (SPD) is one of the processes used to refine the microstructure of materials. Equal Channel Angular Extrusion (ECAE) is the most common method of SPD. In this study, AL-6063grain refinement was performed using the Equal Channel Angular Extrusion method. The material was extruded up to 6 passes at a temperature of 200°C following route A. A suitable die sets equipped w...
متن کاملExperimental and computational analysis of toughness anisotropy in an AA2139 Al-alloy for aerospace applications
Fracture toughness anisotropy of AA2139 (Al-Cu-Mg) in T351 and T8 conditions has been investigated via mechanical testing of smooth and notched specimens of different geometries, loaded in the rolling direction (L) or in the transverse direction (T). Fracture mechanisms were investigated via SEM and synchrotron radiation computed tomography (SRCT). Contributions to failure anisotropy are identi...
متن کاملExperimental Analysis of Toughness in 6156 Al-alloy Sheet for Aerospace Applications
Analysis of toughness in 6156 Al-Mg-Si-Cu sheet has been performed using enhanced Kahn tear tests on samples quenched at different rates, whilst microstructures of the samples have been assessed using differential scanning calorimetry, scanning electron microscopy and transmission electron microscopy. Crack initiation energies were unaffected by changing water quench temperature from 20°C to 60...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Toughness-Strength Relations in the Overaged 7449 Al-Based Alloy
COST reduction is a key objective of modern airframe The 7449 and 7150 plates, respectively 30and 36-mm manufacture. This can be achieved by the design of materials thick, were provided by Pechiney CRV (Voreppe, France) with improved properties leading to weight reduction of the in a solutionized, quenched, and stretched condition (corresairframe structure and, therefore, reduction in fuel cons...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2001
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.42.2386