Experimental Analysis of Solidification Behaviors in Thin-wall LCP Injection Molding
نویسندگان
چکیده
منابع مشابه
Antec 2016 Color Development for Non Warping Thin Wall Injection Molding
Formulating the wide variety of Colors in demand today for thin section injection molding can be challenging. Customers require dimensionally stable parts that often must match or nest in assembly. Colorant selection is critical to meeting today’s demands and this paper describes a system to achieve these goals.
متن کاملStudy on residual stresses of thin-walled injection molding
The residual stresses of the thin-walled injection molding are investigated in this study. It was realized that the behavior of residual stresses in injection molding parts was affected by different process conditions such as melt temperature, mold temperature, packing pressure and filling time. The layer removal method was used to measure the residual stresses at a thin-walled test sample by a...
متن کاملStability analysis of injection molding flows
We numerically investigate the stability problem of the injection molding process. It was indicated by Bulters and Schepens Bulters and Schepens 2000 that surface defects of injection molded products may be attributed to a flow instability near the free surface during the filling stage of the mold. We examine the stability of this flow using the extended Pom–Pom constitutive equations. The mode...
متن کاملPrecision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملImage Analysis Dedicated to Polymer Injection Molding
This work follows the general framework of polymer injection moulding simulation whose objectives are the mastering of the injection moulding process. The models of numerical simulation make it possible to predict the propagation of the molten polymer during the filling phase from the positioning of one point of injection or more. The objective of this paper is to propose a particular way to op...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Seikei-Kakou
سال: 2017
ISSN: 0915-4027,1883-7417
DOI: 10.4325/seikeikakou.29.265