Exergy Cost Analysis of New Method for Efficiency Improvement in Small Gas Turbines Using LNG Cold Exergy

Exergetic Analysis, Optimization and Comparison of LNG Cold Exergy Recovery Systems for Transportation

LNG (Liquefied Natural Gas) shares in the global energy market is steadily increasing. One possible application of LNG is as a fuel for transportation. Stricter air pollution regulations and emission controls have made the natural gas a promising alternative to liquid petroleum fuels, especially in the case of heavy transport. However, in most LNG-fueled vehicles, the physical exergy of LNG is ...

LNG – Based Cogeneration Systems: Evaluation Using Exergy-Based Analyses

Exergy Analysis of Overspray Process in Gas Turbine Systems

Gas turbine power can be augmented by overspray process which consists of inlet fogging and wet compression. In this study exergy analysis of the overspray process in gas turbine system is carried out with a non-equilibrium analytical modeling based on droplet evaporation and the second law of thermodynamics. This work focuses on the effects of system parameters such as pressure ratio, water in...

Impact of Ambient Conditions of Arab Gulf Countries on the Performance of Gas Turbines Using Energy and Exergy Analysis

In this paper, energy and exergy analysis of typical gas turbines is performed using average hourly temperature and relative humidity for selected Gulf cities located in Saudi Arabia, Kuwait, United Arab Emirates, Oman, Bahrain and Qatar. A typical gas turbine unit of 42 MW is considered in this study. The electricity production, thermal efficiency, fuel consumption differences between the ISO ...

Mini two-shaft gas turbine exergy analysis with a proposal to decrease exergy destruction

In this case study, exergy analysis is applied to a mini two-shaft gas turbine which is located in Islamic Azad University Khomeini Shahr Branch`s Thermodynamics laboratory and a proposal presented to make exergy destruction less using a Heat Recovery Water Heater (HRWH). Calculations were done for N2=20000 (rpm) constant and various N1 and after that for N1=600...