Excess Heat Triggering by 488 nm Laser in a D/Pd Gas-Loading System
نویسندگان
چکیده
منابع مشابه
“excess Heat”and“heat after Death”in a Gas- Loading Hydrogen/palladium System
Super-absorption” could occasionaly appear when an H/Pd gas-loaded system was heated by an incandescent tungsten filament. The system-pressure was kept on in 10 Pa for several hours without any aid of pumping. In this stage both “excess heat”and “heat after death”was observed once. By calibration, the feature constant of the system was 12.8°C/W in maximum. When the “excess heat”appeared, the sy...
متن کاملDevelopment of a 488-nm Blue Laser for Biomedical Analyzers
Figure 2 shows the configuration of the blue laser developed here. A 976-nm semiconductor laser is employed as fundamental lightwave generator, and after wavelength stabilization using fiber Bragg grating (FBG), the source light is directly coupled to a SHG wavelength conversion device of planar waveguide type. Because, in single-longitudinal-mode operation, the 976-nm semiconductor laser is su...
متن کاملTreatment of lentigines by a novel high power diode laser at 755 nm: a case report
The use of high-power diode laser with a wavelength of 755 nm is an effective and safe method for the correction and partial and/or total elimination of pigmented lesions, specifically solar lentigines. This wavelength has yet not been used in diode lasers to treat solar lentigines. Side effects are the usual ones, including darkening and scab formation. Our patient was a 40-year-old woman of C...
متن کاملAnomalous Heat Flow and Its Correlation with Deuterium Flux in a Gas-loading Deuterium-palladium System
A special experimental device was designed to test the anomalous thermal effect of Pd with deuterium flux (Df ) caused by deuteron diffusion passing through a thin wall of a Pd tube under a D2 pressure difference across the Pd wall. It is found that the variation of the flux was the significant precursor of the anomalous heat, because a remarkable heat flow was detected when the Df was becoming...
متن کاملHeat Transfer in Semitransparent Medium Caused by Laser Pulse
In this paper, the combination of conduction with radiation into a semitransparent medium which includes absorption, emission and scattering has been investigated. In order to Study the conduction in medium, the Non-Fourier heat conduction has been applied. In this model there is a time delay between heat flux and temperature gradient. Also, in contrast with Fourier heat conduction, the speed o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Materials Research
سال: 2013
ISSN: 1662-8985
DOI: 10.4028/www.scientific.net/amr.834-836.1182