Examination of the Machinability of Eutectic Aluminium Alloys

Machinability of Experimental Ti-Cu Alloys

This study is an investigation of the machinability of experimental Ti-Cu alloys (2, 5, and 10mass% Cu) as new dental titanium alloy candidates for CAD/CAM use. The alloys were slotted with a vertical milling machine and carbide square end mills under two cutting conditions. Their machinability was evaluated through cutting force using a three-component force transducer fixed on the table of th...

Machinability of experimental Ti-Ag alloys.

This study investigated the machinability of experimental Ti-Ag alloys (5, 10, 20, and 30 mass% Ag) as a new dental titanium alloy candidate for CAD/CAM use. The alloys were slotted with a vertical milling machine and carbide square end mills under two cutting conditions. Machinability was evaluated through cutting force using a three-component force transducer fixed on the table of the milling...

Machinability of Titanium Alloys in Drilling

Creep of Aluminium and Aluminium Alloys

This chapter constitutes an introduction to creep and to the creep response of Aluminium and its alloys. Its major goals are: to provide basic information on creep and its mechanisms to give a description of the more extensively used mathematical relations among creep variables (time, stress and temperature) to illustrate the creep response of pure Aluminium and of Al-Mg alloys to provide a syn...

Metallography of Aluminium alloys

This lecture aims at providing a survey of the metallographic techniques available for the examination of aluminium and its alloys. The information must be sufficient to be sure that the students and the users are able to choose the most suitable technique to solve their problems in the examination of samples. The lecture should contain a direct understanding of the main problems in the metallo...