Evolution of the Fe-on-Ti and Ti-on-Fe interfaces under thermal treatment
نویسندگان
چکیده
منابع مشابه
Assessment of the Al–Fe–Ti system
The Al–Fe–Ti system has been assessed and the limiting binary systems are shortly reviewed. Based on a thorough review of the literature, isotherms at 800, 900, and 1000 °C have been re-evaluated and a provisional isotherm at 1200 °C is presented for the first time. The effect of alloying the binary phases with the third component is reviewed with regard to the ternary homogeneity ranges, cryst...
متن کاملDurability of Fe-Co Thin Films on Ti-6Al-4V
The durability of Fe-Co thin films bonded on Ti-6Al-4V was studied as a function of layer thickness at ambient temperature. Interface toughness of the thin films was characterized by indentation and analyzed using an interface fracture model. The critical stresses for interface debonding and the fatigue life response of Ti-6Al-4V with and without Fe-Co thin films were evaluated by three-point b...
متن کاملProduction of Fe-TiN and Fe-Ti(N,C) composite powders by mechanical alloying
In this research, the production of Fe-TiN and Fe-Ti(N,C) composite powders by mechanical alloying was investigated and evaluated. Ferrotitanium (containing 70%Ti), titanium and graphite were used as the raw materials. Initial mixtures were milled in different time durations under the pure nitrogen atmosphere with the pressure of 5atm. The results showed that when N2 pressure is 5 at...
متن کاملPhase equilibria and phase transformations in the Ti-rich corner of the Fe–Ni–Ti system
While the main features of the Fe–Ni–Ti system are well known at low Ti content, literature review of the Ti-rich corner revealed inconsistencies between experimental reports. This investigation presents new experimental results, defined to remove the uncertainties concerning melting behavior and solid-state phase equilibria of the (Ni,Fe)Ti2 phase with the adjacent (Fe,Ni)Ti (B2, CsCl-type str...
متن کاملMicrostructure and Thermal Stability of Fe, Ti, and Ag Implanted Yttria-Stabilized Zirconia
Yttria-stabilized zirconia (YSZ) was implanted with 15 keV Fe or Ti ions up to a dose of 8 x 1016 at cm -2. The resulting "dopant" concentrations exceeded the concentrations corresponding to the equilibrium solid solubility of Fe2Oa or TiO2 in YSZ. During oxidation in air at 400 ° C, the Fe and Ti concentration in the outermost surface layer increased even further until a surface layer was form...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thin Solid Films
سال: 2021
ISSN: 0040-6090
DOI: 10.1016/j.tsf.2021.138551