Evolution of anisotropy of sheet metals during plastic deformation
نویسندگان
چکیده
منابع مشابه
plastic instability in equibiaxial deformation of sheet metals
plastic instability which results in the localization and failure of sheet metals has been studied in equibiaxial stretching of commercial purity aluminium sheet. attention was focussed on two main industrial conditions of the material. these were representative of the materials that could be processed by the commercial batchannealing process (slow heating, long time) or by a continuous anneali...
متن کاملPlastic anisotropy and associated deformation mechanisms in nanotwinned metals
Anisotropic plastic deformation in columnar-grained copper in which preferentially oriented nanoscale twins are embedded is studied by experimental testing, crystal plasticity modeling and molecular dynamics simulations. The dominant deformation mechanism can be effectively switched among three dislocation modes, namely dislocation glide in between the twins, dislocation transfer across twin bo...
متن کاملSevere Plastic Deformation of Metals
This paper provides an introduction in the field of severe plastic deformation (SPD). First of all the main methods to produce SPD materials are discussed. In the following section, the mechanisms leading to the formation of fine grains are reviewed and the influence of changes in strain path is highlighted. During post-SPD thermal annealing, some typical microstructural changes take place. The...
متن کاملStrengthening of Metals through Severe Plastic Deformation
The processing of bulk metals through the application of severe plastic deformation (SPD) provides an opportunity for achieving excellent grain refinement to the submicrometer or even the nanometer range. These SPD procedures produce materials exhibiting improved mechanical properties including very high strength. This report describes recent results demonstrating the strengthening of conventio...
متن کاملMicrostructural Evolution of X45CrNiW189 Valve Steel During Hot Deformation
The hot compression tests were carried on X45CrNiW189 valve steel (X45) in the temperature range of 1000– 1200 °C and the strain rate range of 0.004 – 0.5 s-1 in order to study the high temperature softening behavior of this steel. For the exact prediction of flow stress, the effective stress-effective strain curves were obtained from experiments under various conditions. On the basis of experi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal Sustainable Construction & Design
سال: 2013
ISSN: 2032-7471
DOI: 10.21825/scad.v4i1.746