Evaporation and Condensation Devices for Passive Heat Removal Systems in Nuclear Power Engineering
نویسندگان
چکیده
منابع مشابه
Passive devices for UWB systems
The release from the U.S. Federal Communication Commission (FCC) of the unlicensed use of the Ultra-Wide-Band (UWB) frequency range of 3.1-10.6 GHz, fed the interest for developing communication systems to be used on applications requiring high data rate transmission. The complete success and spreading of these novel applications requires inexpensive and reliable UWB communication systems and d...
متن کاملEvaporation and Condensation Heat Transfer Performance of Flammable Refrigerants in a Brazed Plate Heat Exchanger
Average Nusselt numbers were measured for R22, R290, R290/600a, and R32/152a undergoing evaporation and condensation in a brazed plate heat exchanger. The refrigerants experienced wavy, stratified flow at low heat and mass fluxes, 1.3 kW/m2 to 8.3 kW/m2 and 1.6 kg/m2 s to 19 kg/m 2 s, respectively. Heat transfer correlations from the literature for in-tube and channel flow of refrigerants with ...
متن کاملReliability of Passive Systems in Nuclear Power Plants
Following the IAEA definitions, [1], a passive component does not need any external input or energy to operate and it relies only upon natural physical laws (e.g. gravity, natural convection, conduction, etc.) and/or on inherent characteristics (properties of materials, internally stored energy, etc.) and/or ‘intelligent’ use of the energy that is inherently available in the system (e.g. decay ...
متن کاملwind farm impact on generation adequacy in power systems
در سال های اخیر به دلیل افزایش دمای متوسط کره زمین، بشر به دنبال روش های جایگزین برای تامین توان الکتریکی مورد نیاز خود بوده و همچنین در اکثر نقاط جهان سوزاندن سوخت های فسیلی در نیروگاه های حرارتی به عنوان مهم ترین روش تولید توان الکتریکی مطرح بوده است. به دلیل توجه به مسایل زیست محیطی، استفاده از منابع انرژی تجدید پذیر در سال های اخیر شدت یافته است. نیروگاه های بادی به عنوان یک منبع تولید توان...
15 صفحه اولAn Experimental Comparison of Evaporation and Condensation Heat Transfer Coefficients for HFC-134a and CFC-12
Evaporation of HFC134a inside smooth, horizontal tubes is studied. Te,;ts are made with pure refngerant and with oil-refrigerant mixtures. Heat flux has varied from 2 kW/n? to 10 kW/m . The inner diameter of the tubes are 12 mm. T1.1o evaporators are used, 4 and 10 m long. Oil content is varied from 0 to 2.5 mass percentage (synthetic oil, EXP-0275). Oil free HFC134a is found to have higher hea...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear and Radiation Safety
سال: 2017
ISSN: 2073-6231
DOI: 10.32918/nrs.2017.1(73).03