Evaluation of Electrical Properties in Conductive Injection Molded Products Using Cupper-plated Fiber
نویسندگان
چکیده
منابع مشابه
Fiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملFiber Reinforcement Induced Warpage on Injection Molded Thermoplastics
1 Abstract The warpage characterizations of injection molded plastic parts are not standardized and very challenging due to its complex process. This paper presents a novel examination method of the deformation of injection molded plastic parts especially for fiber reinforced materials. A special, but simple part was introduced for the description of the effect of different technological parame...
متن کاملStudy on Effects of Molded Conditions on the Fiber Orientation and Electrical Conductivity of Injection Molded Bipolar Plate for Fuel Cell
Fuel cells constitute one of the most promising sources of clean energy for the 21 century and bipolar plate is an important component of a PEM fuel cell. Polymers filled with conducting fibers have been chosen as a candidate material for bipolar plates which needs to fulfill the surface conductivity requirement. In the present paper, effect of processing parameters including melt temperature, ...
متن کاملCharacterization and Compression Properties of Injection Molded Carbon Nanotube Composites
Since the development of carbon nanotubes (CNTs) in 1991, they have received much attention with improved mechanical, thermal, and electrical properties of their composites compared to common polymer composites. The CNTs are currently used to increase the modulus of common thermoplastics and thermosets, including urethanes and epoxies. The CNTs are difficult to disperse within any media because...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Seikei-Kakou
سال: 2012
ISSN: 0915-4027,1883-7417
DOI: 10.4325/seikeikakou.24.660