Evaluation of an Analytical Model in the Prediction of Machining Temperature of AISI 1045 Steel and AISI 4340 Steel
نویسندگان
چکیده
منابع مشابه
Expansion and fracture of AISI 1045 steel explosive-filled cylinders
By a improved front light-source framing photography technique and a simple fragments soft recovered method, the expansion and fracture behaviour of the AISI 1045 steel cylinders loaded by three different brisance explosives have been studied . Cylinders were heat treated-normalized and quenched and tempered. Experimental results show that the more intensive of the loading ,the stronger capabil...
متن کاملFinite Element Method Simulation of Machining of AISI 1045 Steel With A Round Edge Cutting Tool
In this paper, FEM modeling and simulation of orthogonal cutting of AISI 1045 steel is studied by using dynamics explicit Arbirary Lagrangian Eulerian method. The simulation model utilizes the advantages offered by ALE method in simulating plastic flow around the round edge of the cutting tool and eliminates the need for chip separation criteria. JohnsonCook work material model is used for elas...
متن کاملInvestigation and Modeling of Electrical Discharge Machining Process Parameters for AISI 4340 steel
N. Annamalai, V. Sivaramakrishnan, B. Suresh kumar, N.Baskar Department of Mechanical Engineering, Mookambigai College of Engineering, Pudukkottai, Tamilnadu, India – 622502 [email protected] * Department of Mechanical Engineering, Roever Engineering College, Perambalur, Tamilnadu, India – 621212 [email protected] #3,*4 Department of Mechanical Engineering, M. A. M. College of Engineeri...
متن کاملOn machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملAn Investigation into the Microstructure of Adiabatic Shear Banding in AISI 1045 Hardened Steel due to High Speed Machining C.Z.Duan
Adiabatic shear banding during high speed machining is important to understand material removal mechanisms. This paper investigates the microstructure of adiabatic shear bands (ASBs) in the serrated chips produced during the high speed machining of AISI 1045 hardened steel. Optical microscope, scanning electronic microscope(SEM) and transmission electronic microscope(TEM) were used to explore t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Manufacturing and Materials Processing
سال: 2018
ISSN: 2504-4494
DOI: 10.3390/jmmp2040074