Evaluation Criteria Fingers Hardness Electrode MEMS comb Converters
نویسندگان
چکیده
منابع مشابه
Design Optimization of MEMS Comb Accelerometer
MEMS (Microelectromechanical Systems) refers to the technology integrating electrical and mechanical components with feature size of 1~1000 microns. MEMS comb accelerometers have been successfully applied for air-bag deployment systems in automobiles. In this paper, the design optimization of a polysilicon surface-micromachined MEMS comb accelerometer is discussed. The device uses folded-beam s...
متن کاملGas Damping Coefficient Research for MEMS Comb Linear Vibration Gyroscope
Silicon-MEMS gyroscope is an important part of MEMS ( Micro Electrical Mechanical System). There are some disturb ignored in traditional gyroscope that must be evaluated newly because of its smaller size (reach the level of micron). In these disturb, the air pressure largely influences the performance of the MEMS gyroscope. Different air pressure causes different gas damping coefficient for the...
متن کاملDesign and Analysis of a MEMS Comb Vibratory Gyroscope
MEMS (Micro-electro-mechanical Systems) refer to devices or systems integrated with electrical and mechanical components in the scale of microns. Due to its small size, low cost, low power consumption and high efficiency, MEMS technology has been widely used in many fields. In this paper, a novel comb-driven, differential capacitance sensing MEMS vibratory gyroscope based on glass-silicon-glass...
متن کاملModeling Methodology for a CMOS-MEMS Electrostatic Comb
A methodology for combined modeling of capacitance and force in a multi-layer electrostatic comb is demonstrated in this paper. Conformal mapping-based analytical methods are limited to 2D symmetric cross-sections and cannot account for charge concentration effects at corners. Vertex capacitance can be higher than 30% of the total capacitance in a single-layer 2 μm thick comb with 10 μm overlap...
متن کاملSelf-assembly technique for MEMS vertical comb electrostatic actuator
We report a very simple and reliable method for making Self-Assembled Vertical Comb (SAVC) drive actuators by using the standard SOI bulk micro-machining processes. The initial angular offset of the movable combs is prepared by using the process stiction which occurs during drying process after sacrificial release. The optical scanner integrated with SAVC has shown good electrostatic scanning p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Biosciences, Biotechnology Research Asia
سال: 2015
ISSN: 0973-1245
DOI: 10.13005/bbra/1910