Estimation of Dislocation Density for AISI 304 Steel After Plastic Deformation Using Non-destructive Methods
نویسندگان
چکیده
منابع مشابه
Non-Destructive Technique of Determining Plastic Deformations Using Pulse Transmission and Acoustic Emission Transducers in 304 Stainless Steel
An empirical method of non-destructive testing of a material was developed using pulse transmission by acoustic emission transducers to determine plastic deformation of 304 stainless steel specimens. This was done by means of comparison of pulse signals detected in an undeformed section with the pulse signals detected after passing through the deformation zone in the specimens. The pulse signal...
متن کاملDesign optimization of cutting parameters for turning of AISI 304 austenitic stainless steel using Taguchi method
In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....
متن کاملGrain Size Effect on the Hot Deformation Processing Map of AISI 304 Austenitic Stainless Steel
In this study, the hot deformation processing map of AISI 304 austenitic stainless steel in two initial grain sizes of 15 and 40 μm was investigated. For this purpose, cylindrical samples were used in the hot compression test at the temperature range of 950-1100 °C and the strain rate of 0.005-0.5% s-1. At first, the relationship between the peak stress and Zener-Hollomon parameter w...
متن کاملDislocation Mechanisms of Plastic Deformation of Ice
Characters and properties of dislocations in ice are thoroughly reviewed on the basis of the knowledge hitherto obtained by the X-ray topographic method as well as recently found dynamical behavior. Extremely low energy of the faults on the basal plane found by the method leads us to conclude that all of the dislocations in ice should be extended as wide as several tens to one hundred nano-mete...
متن کاملRegression analysis of shot peening process for performance characteristics of AISI 304 austenitic stainless steel
The surface fibers of the material are yielded in tension by the impact of shots in shot peening process. Below the surface fiber an even thin skin surface layer of material is deformed and this layer is highly stressed in compression. It results in the improvement of surface and mechanical properties of the material. Regression analysis is the statistical modeling technique, and it is suitable...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Physica Polonica B Proceedings Supplement
سال: 2021
ISSN: 1899-2358,2082-7865
DOI: 10.5506/aphyspolbsupp.14.591