Estimating the Sway Angle of an Overhead Crane by an Observer Using Angular Velocity Sensors
نویسندگان
چکیده
منابع مشابه
an investigation into translation of cultural concepts by beginner and advance student using think – aloud protocols
this research aims at answering the questions about translation problems and strategies applied by translators when translating cultural concepts. in order to address this issue, qualitative and quantitative study were conducted on two groups of subjects at imam reza international university of mashhad. these two groups were assigned as beginner and advanced translation students (10 students). ...
Innovative Control of an Overhead Crane System
Satisfactory real time control of the overhead crane facilitating fast transit (< 3s) and minimal swing (< 4°) was achieved in the x, y and z directions. Control was achieved in each individual direction using experimental modelling techniques, careful sampling frequency selection, NMSS representation and LQR controller design. To overcome non-linear model variation, a gain scheduling algorithm...
متن کاملdesign optimization of box type girder of an overhead crane
double bridge girder overhead cranes are used for heavy duty applications in theindustry. in this paper a detailed parametric design optimization of the main girder of box type isperformed for a 150ton capacity and 32m long span crane, after its basic design using availabledesign rules. design optimization is performed using detailed 3d finite element analysis bychanging the number, shape and l...
متن کاملNonlinear Observers Applied to the Control of an Overhead Crane
This paper addresses the asymptotic output tracking problem for the model of an overhead crane. It is shown that the model is linearizable by dynamic state feedback when the full state is available for measurement. In the more realistic situation when the angle that the rope forms with respect to the vertical axis cannot be measured, two different nonlinear observers are used in order to estima...
متن کاملAngular velocity nonlinear observer from vector measurements
This paper proposes a technique to estimate the angular velocity of a rigid body from vector measurements. Compared to the approaches presented in the literature, it does not use attitude information nor rate gyros as inputs. Instead, vector measurements are directly filtered through a nonlinear observer estimating the angular velocity. Convergence is established using a detailed analysis of th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 2006
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.72.3201