Erratum to: Surface grafting of bamboo fibers with 1,2-epoxy-4-vinylcyclohexane for reinforcing unsaturated polyester
نویسندگان
چکیده
منابع مشابه
Unsaturated Polyester Resin for Specialty Applications
Polymers are substances whose molecules consist of a large number of units of a few types: the units themselves, consisting of a number of atoms, are usually referred to as the segments of the polymer. In the polymerization of a mixture of two monomers, the structure of each macromolecule contains units of both monomers. Such a polymer is called copolymer and the process of its synthesis is cal...
متن کاملPolyester Nanocomposite fibers with Antibacterial Properties
Antibacterial nanocomposite polyester (PET) fibres were melt spun by adding nano ZnO loaded Linear Low Density Polyethylene (LLDPE) master batch (MB) to the PET chips. The influence of content of nano ZnO on the antibacterial properties, crystallization behaviour and mechanical properties was studied. It was found that PET composite fibres having 1 % nano ZnO showed the optimum antibacterial ac...
متن کاملMechanical Properties of Unsaturated Polyester Resin
Mechanical behaviour of unsaturated polyester resin used for the composite materials has been studied to determine various important parameters, such as tensile and compressive, single edge-notch tensile fracture toughness, flexural properties and fracture energy. Fracture toughness, KIC, and fracture energy, GIC, obtained for the polyester resin lie between the typical values for epoxy resins ...
متن کاملRecycling of Waste Epoxy-Polyester Powders for Foam Production
This paper proposes a new foaming technology (solid-state foaming) to produce structural foams from waste thermosetting resins. The proposed technology is easy and does not require specific and expensive equipments. Solid tablets are produced by cold compaction of resin powder, and foam by heating in an oven. Composite foams can be produced by mixing fillers and resin powder before the cold com...
متن کاملMechanical Properties and Water Absorption of Hemp Fibers–Reinforced Unsaturated Polyester Composites: Effect of Fiber Surface Treatment with a Heterofunctional Monomer
Hemp fibers–reinforced unsaturated polyester (UP) composites were prepared by hand lay-out compression molding. Hemp fibers were treated with isocyanatoethyl methacrylate (IEM), using dibutyltin dilaurate as a catalyst. The results indicated that fiber treatment significantly increased tensile strength, flexural strength, flexural modulus, and water resistance of the resulting composites, and y...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Cellulose
سال: 2017
ISSN: 0969-0239,1572-882X
DOI: 10.1007/s10570-017-1534-0