Erratum for “Instability, Ductility, and Size Effect in Strain-Softening Concrete”
نویسندگان
چکیده
منابع مشابه
Vertex Effect in Strain-Softening Concrete at Rotating Principal Axes
The inelastic behavior of concrete for highly nonproportional loading paths with rotating principal stress axes is studied. Test cylinders are first loaded in compression under uniaxial stress and then torsion is applied at constant axial displacement. Proportional compressive-torsional loading tests are also carried out for comparison. The tests demonstrate that the response of concrete for lo...
متن کاملEffect of Length on Compressive Strain Softening of Concrete
The concept of localization during the postpeak of compressive strain softening is presented. To explore localization in compression, a feedback-control method using a linear combination of displacement and force that partially subtracts the elastic response of the specimen to give a stable feedback signal is used. Results are presented from two test series (45 and 90 MPa) that use this method ...
متن کاملDuctility of Confined Concrete
Are structural engineers designing concrete structures with greater capacity and safety than they realize? By exploring effects of confinement in order to incorporate them in usual design procedures of engineering consulting companies, concrete structures will possibly in the future be both stronger, thinner and have a greater ability to deform prior to failure – three properties that are highl...
متن کاملFrictional Strain Hardening-softening in Experimental and Numerical Investigation of Arching Effect
In the current paper the results of a numerical simulation that were verified by a well instrumented experimental procedure for studying the arching effect over a trapdoor in sand is presented. To simulate this phenomenon with continuum mechanics, the experimental procedure is modeled in ABAQUS code using stress dependent hardening in elastic state and plastic strain dependent frictional harden...
متن کاملShear Localization due to Strain Softening in Side Pressed Cylinders
In this paper, shear localization due to strain softening in sidepressed cylinders, is inverstigated. Shear localization causes formation of macroscopic shear bands which can be obsserved in the metallographic cross-section. In this paper, for the first time a method is presented in which a simple two-slice model is used to study the formation of shear bands. The results obtained form this mode...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Engineering Mechanics Division
سال: 1977
ISSN: 0044-7951,2690-2427
DOI: 10.1061/jmcea3.0002212