Erratum for “Electronic Surveying: Electronic Distance Measurements”
نویسندگان
چکیده
منابع مشابه
Electronic Textiles for in Situ Biomechanical Measurements
This paper describes the benefits of and issues in designing and building an integrated, body-worn electronic textile (e-textile) system capable of assessing a suite of biomechanical measures. Unlike laboratorybased systems, this system would be worn by a soldier and could be used in a range of environmental conditions. A prototype e-textile developed at Virginia Tech has already shown promisin...
متن کاملsimulation and design of electronic processing circuit for restaurants e-procurement system
the poor orientation of the restaurants toward the information technology has yet many unsolved issues in regards to the customers. one of these problems which lead the appeal list of later, and have a negative impact on the prestige of the restaurant is the case when the later does not respond on time to the customers’ needs, and which causes their dissatisfaction. this issue is really sensiti...
15 صفحه اولSingle-Molecule Electronic Measurements with Metal Electrodes
The process of transferring electrons from one metal electrode to another via an intervening molecule differs from electrochemically or optically-induced electron transfer in important ways. The simplest process of ballistic electron transport with no charge localization on the molecule (tunneling) should be easy to understand quantitatively, yet experimental reports and theoretical calculation...
متن کاملElectronic cigarette aerosol particle size distribution measurements.
The particle size distribution of aerosols produced by electronic cigarettes was measured in an undiluted state by a spectral transmission procedure and after high dilution with an electrical mobility analyzer. The undiluted e-cigarette aerosols were found to have particle diameters of average mass in the 250-450 nm range and particle number concentrations in the 10(9) particles/cm(3) range. Th...
متن کاملA technique for fabricating patterns for removable partial denture frameworks using digitized casts and electronic surveying.
Although computer-aided design and manufacture techniques have shown some promising applications in the fabrication of crowns, inlays, and maxillofacial and oral surgery, the field of removable prosthodontics has not embraced these technologies so far. This article describes the development and investigation of computer-aided techniques that may eventually enable prosthodontic procedures such a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surveying and Mapping Division
سال: 1964
ISSN: 0569-8073,2690-3407
DOI: 10.1061/jsueax.0000170