Erratum: Control of melt‐front velocity during pulsed laser annealing
نویسندگان
چکیده
منابع مشابه
Dense-plasma Dynamics during Pulsed Laser Annealing
The flow of energy from the laser to the lattice during pulsed laser annealing of Si is examined, with particular attention paid to the influence of the dense'plasma of hot, photoexcited carriers on-the manner in which this energy transfer occurs. Consideration of carrier thermalization and recombination at high carrier densities suggests that under certain conditions carrier diffusion may incr...
متن کاملcontrol of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولInterface kinetics during pulsed laser ablation
This work investigates evaporation kinetics — the relation between the surface temperature and pressure during excimer laser ablation. Nickel targets are ablated by excimer laser pulses in a laser fluence range between 1 and 6 J/cm2, with the upper limit exceeding the threshold of phase explosion (5 J/cm2). The surface pressure is determined with a polyvinylidene fluoride (PVDF) piezoelectric t...
متن کاملHeat accumulation during pulsed laser materials processing.
Laser materials processing with ultra-short pulses allows very precise and high quality results with a minimum extent of the thermally affected zone. However, with increasing average laser power and repetition rates the so-called heat accumulation effect becomes a considerable issue. The following discussion presents a comprehensive analytical treatment of multi-pulse processing and reveals the...
متن کاملSpatially resolved flow velocity measurements using laser-induced fluorescence from a pulsed laser.
We describe how spatially resolved velocity measurements can be acquired using a pulse-amplified single-mode cw laser with a potential of single-shot measurements. The laser beam was tuned to the point of maximum slope of a Doppler-broadened absorption profile of I(2), which was seeded into the flow. The beam was then split into two components and sent counterpropagating through the measurement...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Physics Letters
سال: 1981
ISSN: 0003-6951,1077-3118
DOI: 10.1063/1.92891