Environmental fatigue correction factor model for domestic nuclear-grade low-alloy steel
نویسندگان
چکیده
منابع مشابه
Identification of Low Cycle Fatigue Parameters of High Strength Low-alloy (hsla) Steel at Room Temperature
S. Bulatović, Yugoslav River Shipping, Serbia, Lj. Milović, University of Belgrade, Faculty of Technology and Metallurgy, Serbia, A. Sedmak, University of Belgrade, Faculty of Mechanical Engineering, Serbia, I. Samardžić, University of Osijek, Mechanical Engineering Faculty, Slavonski Brod, Croatia Low cycle fatigue test was performed in ambient atmosphere at room temperature. Cycle loading of ...
متن کاملThe Effect of Pre-strain on Fatigue for a High Strength Low Alloy (hsla)steel
D. Aguirre-Guerrero, A. Juárez-Hernández, M.A.L. Hernández-Rodríguez, University Autonumous of Nuevo León, Faculty of Mechanical and Electrical Engineering, Nuevo León, México. R. Morales, I. Ruiz, PEMSA Co. Celaya, Guanajuato, México. The eff ect of initial plastic strain c ycle fatigue lives of HSLA specimens is in vestigated. Specimens were monotonically, quasi-statically loaded under strain...
متن کاملFatigue and corrosion fatigue properties of Ti-6Al-4V implant grade titanium alloy in Ringer solution
Nowadays modification of metallic biomaterials which are used as implants for bone and hard tissues replacement is considered as an important subject. In the current study, corrosion fatigue properties of Ti-6Al-4V alloy investigated via Rotating-Bending standard test method and then, the results compared with the fatigue properties of the specimens tested in the same conditions. Scanning elect...
متن کاملA new low cycle fatigue lifetime prediction model for magnesium alloy based on modified plastic strain energy approach
Nowadays, the technology intends to use materials such as magnesium alloys due to their high strength to weight ratio in engine components. As usual, engine cylinder heads and blocks has made of various types of cast irons and aluminum alloys. However, magnesium alloys has physical and mechanical properties near to aluminum alloys and reduce the weight up to 40 percents. In this article, a new ...
متن کاملA Modified Energy-based Low Cycle Fatigue Model for Eutectic Solder Alloy
Surface mount technology (SMT) is increasingly used in microelectronics to mount components by soldering onto the printed circuit board (PCB). The solder alloys are used as the electrical and mechanical connections between the component and the board. Fatigue failure of solder joints is recognized as a major cause of failure in electronic devices. An approach to this problem is to determine the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear Engineering and Technology
سال: 2021
ISSN: 1738-5733
DOI: 10.1016/j.net.2021.02.014