Enhancing Impact Strength of Fused Deposition Modeling Built Parts using Polycarbonate Material
نویسندگان
چکیده
منابع مشابه
Curved Layer Fused Deposition Modeling
Current Fused Deposition Modeling (FDM) technologies deposit material as flat layers. The result is a “stair-case” effect on non-vertical or horizontal surfaces, and compromised part strength because of weakness between the laminations. This paper describes a FDM method through which layers of build material are deposited as curved layers following the shape of the part, thus removing the stair...
متن کاملMethods to Improve Surface Finish of Parts Produced by Fused Deposition Modeling
Fused deposition modeling (FDM) is one of the rapid prototyping technologies that can use plastic material, which can be effectively used for making patterns for investment casting. The surface finish of the investment casting depends upon the surface finish of the pattern. But the surface finish of the parts produced by using FDM is not very good as compared to wax patterns, which are conventi...
متن کاملFinishing of ABS-M30 Parts Manufactured with Fused Deposition Modeling With Focus on Dimensional Accuracy
Fused Deposition Modeling (FDM) parts are prone to process-related rough and wavy surfaces with stair-stepping effects whenever the parts produced have sloped or rounded geometries. These stair-stepping effects can be reduced by using a smaller slice height, but complete elimination is not possible. In this paper, FDM parts manufactured with the material ABS-M30 are finished using mass finishin...
متن کاملSome Investigations Regarding the Surface Treatment of Ultem*9085 Parts Manufactured with Fused Deposition Modeling
Fused Deposition Modeling (FDM) parts are typically subject to process-related rough or wavy surfaces, with stair-stepping effects whenever the parts produced have sloped or rounded part geometries; however, the level of optical quality frequently required demands that parts feature a smooth surface. In this paper, the results of a high-energy finishing process, which uses a disc finishing unit...
متن کاملImpact Strength of High Density Solid-State Microcellular Polycarbonate Foams
The effect of density (relative densities 0.33 to 0.90) on the impact behavior of microcellular polycarbonate (PC) was investigated. Cell size and foaming gas content were also considered. Flexed-beam Izod impact tests were conducted and the impact strength of these foams appears to be a strong function of both density and cell size. The impact strength was observed to improve over the unproces...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indian Journal of Science and Technology
سال: 2016
ISSN: 0974-5645,0974-6846
DOI: 10.17485/ijst/2016/v9i34/100983