Enhancement of n-type GaN (20–21) semipolar surface morphology in photo-electrochemical undercut etching

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Surface Morphology and Formation of Nanostructured Porous GaN by UV-assisted Electrochemical Etching

This article reports on the studies of porous GaN prepared by ultra-violet (UV) assisted electrochemical etching in a solution of 4:1:1 HF: CH3OH:H2O2 under illumination of an UV lamp with 500 W power for 10, 25 and 35 minutes. The optical properties of porous GaN sample were compared to the corresponding as grown GaN. Porosity induced photoluminescence (PL) intensity enhancement was found in t...

متن کامل

Photoelectrochemical undercut etching for fabrication of GaN microelectromechanical systems

The authors have developed a wet, band-gap-selective, photoelectrochemical etching process capable of producing cantilever microelectromechanical systems from InGaN/GaN heterostructures. Fabricated cantilevers were successfully actuated, and resonance spectra were measured. The as-grown strain gradient in the GaN film was found to relax upon removal, resulting in upward curvature of the cantile...

متن کامل

Photo-Enhanced Etching of n-Si

The etch rate of n-type Si in diluted HF solutions was investigated as a function of the bias voltage applied to the Si/electrolyte interface in the dark and under illumination. It was observed that the etch rate depends very sensitively on the minority carrier flow through this interface. For an illumination intensity of 5.3x 1016 photons/cm2s (2 = 550 nm) and the depleted Si/electrolyte inter...

متن کامل

Inverse GaN Pyramids for Semipolar GaInN/GaN Light-Emitting Diodes

Excellent semipolar GaN material quality can be obtained by growing inverse GaN pyramids on full 2 inch c-plane sapphire when combining the advantages of defect reduction via FACELO and selective area growth for faceted surfaces. The nearly defect free material is obtained by structuring the mask into a honeycomb pattern. When realizing full GaInN/GaN LED structures on those templates, a relati...

متن کامل

Nanorods on surface of GaN-based thin-film LEDs deposited by post-annealing after photo-assisted chemical etching

This study investigates the optoelectronic characteristics of gallium nitride (GaN)-based thin-film light-emitting diodes (TF-LEDs) that are formed by a two-step transfer process that involves wet etching and post-annealing. In the two-step transfer process, GaN LEDs were stripped from sapphire substrates by the laser lift-off (LLO) method using a KrF laser and then transferred onto ceramic sub...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Applied Physics Express

سال: 2019

ISSN: 1882-0778,1882-0786

DOI: 10.7567/1882-0786/ab028d