Enhanced Low-Neutron-Flux Sensitivity Effect in Boron-Doped Silicon
نویسندگان
چکیده
منابع مشابه
Superconductivity in heavily boron-doped silicon carbide.
The discoveries of superconductivity in heavily boron-doped diamond in 2004 and silicon in 2006 have renewed the interest in the superconducting state of semiconductors. Charge-carrier doping of wide-gap semiconductors leads to a metallic phase from which upon further doping superconductivity can emerge. Recently, we discovered superconductivity in a closely related system: heavily boron-doped ...
متن کاملPerformance of silicon microdosimetry detectors in boron neutron capture therapy.
Reverse-biased silicon p-n junction arrays using Silicon-On-Insulator technology have been proposed as microdosimeters. The performance of such detectors in boron neutron capture therapy (BNCT) is discussed. This work provides the first reported measurements using boron-coated silicon diode arrays as microdosimeters in BNCT. Results are in good agreement with measurements with gas proportional ...
متن کاملParameter Sensitivity Analysis Applied to Modeling Transient Enhanced Diffusion and Activation of Boron in Silicon
Transient enhanced diffusion ~TED! during annealing of implanted boron in silicon greatly impedes the formation of junctions that are sufficiently shallow for advanced complementary metal oxide semiconductor devices. For reasons of cost and efficiency in process development, detailed modeling of TED is often used for designing annealing procedures. However, because model validation depends prim...
متن کاملIntrinsic Stress of Heavily Boron-doped Silicon Microstructures
Heavily boron-doped silicon microstructures fabricated using deep-boron diffusions and boron etch-stops have been widely used in a variety of integrated sensors and actuators. For many applications, having knowledge of the mechanical properties such as Young's modulus, intrinsic stress, and fracture stress of these films is very important in predicting the response parameters of the sensors and...
متن کاملMillisecond Microwave Annealing of Ultra-shallow Boron Doped Silicon
Next generation Si IC transistors, i.e. the 65 nm node, will require ultra-shallow doped regions with depths less than 17 nm and concentrations high enough to get a sheet resistance, Rs, lower than 760 ohms/square [1]. The current state of implant technology, taking into account reasonable throughput and cost considerations, results in as-implanted junction profiles that are slightly shallower ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nanomaterials
سال: 2020
ISSN: 2079-4991
DOI: 10.3390/nano10050886