Energy circulation methods for surface acoustic wave motor
نویسندگان
چکیده
منابع مشابه
Analysis of a Surface Acoustic Wave Motor
− Based on first principles a dynamical contact model of a Surface Acoustic Wave motor is built. Besides slider behavior also contact point behavior is obtained, which is hard to acquire experimentally. The contact point behavior is used to explain slider behavior like threshold amplitude and like oscillations that are observed in experimental set-ups.
متن کاملComparison of Transmission Line Methods for Surface Acoustic Wave Modeling
Surface Acoustic Wave (SAW) technology is low cost, rugged, lightweight, extremely low power and can be used to develop passive wireless sensors. For these reasons, NASA is investigating the use of SAW technology for Integrated Vehicle Health Monitoring (IVHM) of aerospace structures. To facilitate rapid prototyping of passive SAW sensors for aerospace applications, SAW models have been develop...
متن کاملElastic friction drive of surface acoustic wave motor.
Importance of elastic deformation control to obtain large output force with a surface acoustic wave (SAW) motor is discussed in this paper. By adding pre-load to slider, stator and slider surfaces are deformed in a few tens nanometer. Appropriate deformation in normal direction against normal vibration displacement amplitude of SAW existed. By moderate deformation, the output force of the SAW m...
متن کاملTiO2 based surface acoustic wave gas sensor with modified electrode dimensions for enhanced H2 sensing application
The design and optimization of nanostructure-based surface acoustic wave (SAW) gas sensor is analyzed based on TiO2 sensing layer and modified electrode dimensions. The sensitivity of the gas sensor depends upon the type of sensing layer used and active surface area obtained by varying the aspect ratio. The performance of the sensor is observed from 0.1ppm to 100ppm concentration of ...
متن کاملA Comparison of Surface Acoustic Wave Modeling Methods
Surface Acoustic Wave (SAW) technology is low cost, rugged, lightweight, extremely low power and can be used to develop passive wireless sensors. For these reasons, NASA is investigating the use of SAW technology for Integrated Vehicle Health Monitoring (IVHM) of aerospace structures. To facilitate rapid prototyping of passive SAW sensors for aerospace applications, SAW models have been develop...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics and Communications in Japan (Part III: Fundamental Electronic Science)
سال: 2003
ISSN: 1042-0967,1520-6440
DOI: 10.1002/ecjc.10132