Energy and Exergy Analyses of Different Aluminum Reduction Technologies

Energy and Exergy Analyses of a Diesel Engine Running on Biodiesel Fuel

Availability analysis is an effective approach to studying energy conversion in systems and identifying inefficiency. In the present study, a single-zone model was used to examine energy performance parameters and heat release rates. The governing equation of availability analysis was applied in the model, and the possibility of using biodiesel produced from sunflower oil as diesel engine was i...

Energy and exergy analyses of a gasoline engine

This study presents comparative energy and exergy analyses of a four-cylinder, four-stroke spark-ignition engine using gasoline fuels of three different research octane numbers (RONs), namely 91, 93 and 95.3. Each fuel test was performed by varying the engine speed between 1200 and 2400 rpm while keeping the engine torque at 20 and 40Nm. Then, using the steady-state data along with energy and e...

ENVIRONMENTAL IMPACTS OF ENERGY-EFFICIENT TECHNOLOGIES: POTENTIAL FOR INPUT-OUTPUT AND SUPPLY-CHAIN ANALYSES IN IRAN

Potential and Evolution of Compressed Air Energy Storage: Energy and Exergy Analyses

Energy storage systems are increasingly gaining importance with regard to their role in achieving load levelling, especially for matching intermittent sources of renewable energy with customer demand, as well as for storing excess nuclear or thermal power during the daily cycle. Compressed air energy storage (CAES), with its high reliability, economic feasibility, and low environmental impact, ...

Evaluation of energy efficiency in biofuel drying by means of energy and exergy analyses

The calculation of heat consumption is based on the First Law and it gives quantitative information about the energy used in drying. However, it does not pay any attention to the quality of the energy used in drying. To take into account the quality of the energy, attention must be paid to the Second Law, too. Especially in those cases where the energy used in drying may be converted to mechani...