Empirical formula for fatigue strength of single-spot-welded joints under tensile-shear load.
نویسندگان
چکیده
منابع مشابه
Three-Dimensional Finite Element Analysis of Tensile-Shear Spot-Welded Joints in Tensile and Compressive Loading Conditions
Выполнен трехмерный конечноэлементный анализ образцов с одним, тремя и пятью точеч ными сварными швами при растяж ении и сжатии. Д ля расчета на прочность исполь зуется распределение упругопластических напряжений в корне точечного шва. Предложена методика субмоделирования, позволяющая получить более точные результаты конечно элементного расчета точечных швов малых размеров. Схема численного ...
متن کاملImproving Fatigue Strength of Welded Joints by Ultrasonic Impact Treatment
Enhancement in fatigue performance of welded joints by Ultrasonic Impact Treatment (UIT) was evaluated with large-scale rolled beam and built-up specimens having yield strength of 345 to 760 MPa. Eighteen rolled-beam specimens having welded details at cover plates and transverse stiffeners and eight built-up specimens having only transverse stiffener details were fatigue tested after treating t...
متن کاملFatigue Life of Repaired Welded Tubular Joints
In this study, the effect of repair on fatigue life of tubular joints is investigated. Six cracked specimens precedently subjected to fatigue loading undergone to weld repair. Two of those specimens were shot peened before primary fatigue loading. It is shown that repair gives rise to about 150% increase in fatigue life for original specimens while the increase of fatigue life for shot-peened ...
متن کاملInvestigation on Tensile Strength of Friction Stir Welded Joints in PP/EPDM/Clay Nanocomposites
Polymer-based nanocomposites due to their advantages such as corrosion resistance,adequate mechanical properties and low cost are widely used in modern technologies. The increasing application of these nanocomposites, and hence their welding seems unavoidable. In this paper, a novel hottool in friction stir welding process is used for butt welding nanocomposite plates of 5 mm thick containing p...
متن کاملMicrostructure and Tensile-Shear Properties of Resistance Spot-Welded Medium Mn Steel
The medium Mn steels are gaining increasing attention due to their excellent combination of mechanical properties and material cost. A cold-rolled 0.1C5Mn medium Mn steel with a ferrite matrix plus metastable austenite duplex microstructure was resistance spot-welded with various welding currents and times. The nugget size rose with the increase of heat input, but when the welding current excee...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 1986
ISSN: 0288-4771
DOI: 10.2207/qjjws.4.639