Electrostatic Lattice Energy of PbSO4, BaSO4, SrSO4and CaSO4
نویسندگان
چکیده
منابع مشابه
The MSXX Force Field for the Barium Sulfate-Water Interface
A new force field (MSXX FF) was developed for barium sulfate (BaSO4) to reproduce the experimental properties of BaSO4 crystal (density, lattice energy, compressibility, and vibrational spectrum) and to describe properly the interaction between BaSO4 and water (binding energies and interatomic distances of Ba(H2O)8 and (SO4)(H2O)6 clusters determined from ab initio quantum mechanics calculation...
متن کاملElectrostatic Swing Energy Harvester
Generation of the electric power by permanently polarized (electret containing) capacitor is analyzed and investigated in the matter of energy harvesting from oscillations and rotation. Experimentally demonstrated the generation of short high-voltage (up to 1 MV) pulses or low voltage (few volts) alternating current that can be rectified and stored.
متن کاملCalculation of Electrostatic Interlayer Bonding Energy a N D Lattice Energy of Polar Phyllosilicates: Kaolinite a N D Chlorite
-The electrostatic lattice energy of polar phyllosilicates can be calculated when a correction term E .... equal to -2r is taken into account, where/~ is the dipole moment of a slice d(001) and V is the molecular volume. The interlayer bonding energy can be obtained by Giese's method, if the energy of separation of the layers over a distance A is plotted againts 1/[d(001) + A]. Thus, for a pola...
متن کاملFlexible substrate electrostatic energy harvester
Energy harvesting is attractive for powering wireless sensors, especially in applications such as body sensor networks and pervasive sensing, where power source replacement or recharging is impractical. A MEMS (micro-electro-mechanical systems) electrostatic harvesting device suitable for body motion has been reported previously, using a rolling rod as the proof mass. A new rolling rod device i...
متن کاملGypsum-bonded investment and dental precision casting (IV) transformation of III-CaSO4 to II-CaSO4.
The degree of III-CaSO4 to II-CaSO4 transition was estimated on wet specimens, 25 mm in diameter and 50 mm high, prepared from a gypsum-bonded investment for quick casting. After 30 min from mixing the specimens were heated in a 700 degrees C furnace until a specimen temperature of 200 degrees C to 700 degrees C was reached. The estimation was made by measuring mass changes of the specimens bef...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Chemical Society of Japan
سال: 1953
ISSN: 0009-2673,1348-0634
DOI: 10.1246/bcsj.26.283