Electrostatic charging measurements of pneumatically transported powders using vibration-type electrostatic field sensor
نویسندگان
چکیده
منابع مشابه
Electrostatic charging of jumping droplets.
With the broad interest in and development of superhydrophobic surfaces for self-cleaning, condensation heat transfer enhancement and anti-icing applications, more detailed insights on droplet interactions on these surfaces have emerged. Specifically, when two droplets coalesce, they can spontaneously jump away from a superhydrophobic surface due to the release of excess surface energy. Here we...
متن کاملIon-induced electrostatic charging of ice
We studied electrostatic charging on amorphous ice films induced by the impact of 100 keV Ar ions at 45 incidence. We derived the positive surface electrostatic potential from the kinetic energy of sputtered molecular ions. Measurements were performed as a function of film thickness, ion flux and accumulated fluence. The main results are (a) films charge up to a saturation value, following an e...
متن کاملElectrostatic charging of trigger actuated spray devices
Electrostatic charging has long been used to improve the efficiency of a range of sprayed liquids. However, the benefits have not until recently been available for exploitation by domestic sprays due to the need for a high voltage power supply. A minimum charge-to-mass ratio (q/m) of 1 × 10 C/kg is generally considered necessary to elicit electrostatic benefits. This level of charge can now be ...
متن کاملLocal Electrostatic Charging of Semiconductor Thin Films
A nanocrystalline diamond (NCD) thin film (80 nm) is deposited on a p-type Si substrate and oxygen terminated by radio frequency (r.f.) oxygen plasma. An atomic force microscope (AFM) is used to induce electrostatically charged micrometer-sized areas on the diamond film by applying a bias voltage on the AFM tip during contact mode scan. Trapped charge is detected by Kelvin force microscopy (KFM...
متن کاملCharacterisation of an Electrostatic Vibration Harvester
Harvesting energy from ambient vibration is proposed as an alternative to storage based power supplies for autonomous systems. The system presented converts the mechanical energy of a vibration into electrical energy by means of a variable capacitor, which is polarized by an electret. A lumped element model is used to study the generator and design a prototype. The device has been micromachined...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Occupational Safety and Health
سال: 2016
ISSN: 1882-6822,1883-678X
DOI: 10.2486/josh.josh-2015-0017-cho