Electronically decoupled stacking fault tetrahedra embedded in Au(111) films

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Electronically decoupled stacking fault tetrahedra embedded in Au(111) films

Stacking faults are known as defective structures in crystalline materials that typically lower the structural quality of the material. Here, we show that a particular type of defect, that is, stacking fault tetrahedra (SFTs), exhibits pronounced quantized electronic behaviour, revealing a potential synthetic route to decoupled nanoparticles in metal films. We report on the electronic propertie...

متن کامل

Mobility and coalescence of stacking fault tetrahedra in Cu

Stacking fault tetrahedra (SFTs) are ubiquitous defects in face-centered cubic metals. They are produced during cold work plastic deformation, quenching experiments or under irradiation. From a dislocation point of view, the SFTs are comprised of a set of stair-rod dislocations at the (110) edges of a tetrahedron bounding triangular stacking faults. These defects are extremely stable, increasin...

متن کامل

Atomic-scale dynamic process of deformation-induced stacking fault tetrahedra in gold nanocrystals.

Stacking fault tetrahedra, the three-dimensional crystalline defects bounded by stacking faults and stair-rod dislocations, are often observed in quenched or irradiated face-centred cubic metals and alloys. All of the stacking fault tetrahedra experimentally observed to date are believed to originate from vacancies. Here we report, in contrast to the classical vacancy-originated ones, a new kin...

متن کامل

Conelike Soap Films Spanning Tetrahedra

In this paper we provide the first examples of non-flat soap films proven to span tetrahedra. These are members of a continuous two parameter family of soap films with tetrahedral boundaries. Of particular interest is a two parameter subfamily where each spanning soap film has the property that two minimal surfaces meet along an edge of the boundary at an angle greater than 120.

متن کامل

Observation of Stacking Fault Tetrahedral in TWIP Steel

Low stacking fault energy face centered cubic (FCC) materials contain characteristic defect structures. Stacking fault tetrahedral are one of those rare structures that occur under special experimental conditions. For the first time, stacking fault tetrahedral were observed in Fe-30Mn-3Al-3Si twinning induced plasticity (TWIP) steel. Their presence resulted from a quenching heat treatment.

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Nature Communications

سال: 2016

ISSN: 2041-1723

DOI: 10.1038/ncomms14001