Electronic stopping calculated using explicit phase shift factors
نویسندگان
چکیده
منابع مشابه
Digital Binary Phase-shift Keyed Signal Detector
We have developed the effective algorithm for detecting digital binary phase-shift keyed signals. This algorithm requires a small number of arithmetic operations over the signal period. It can be relatively easy implemented based on the modern programmable logic devices. It also provides high interference immunity by identifying signal presence when signal-to-noise ratio is much less that its w...
متن کاملCalculated LET spectrum from antiproton beams stopping in water.
INTRODUCTION Antiprotons have been proposed as a potential modality for radiotherapy because the annihilation at the end of range leads to roughly a doubling of physical dose in the Bragg peak region. So far it has been anticipated that the radiobiology of antiproton beams is similar to that of protons in the entry region of the beam, but very different in the annihilation region, due to the ex...
متن کاملGAS-PHASE ACIDITY OF SOME CARBOXYLIC ACIDS CALCULATED BY MNDO
Gas-phase acidities of 15 aliphatic carboxylic acids, X CH -,COOH, have been calculated using the MNDO method. Among the substituted groups exist the electron donor alkyl groups and electron acceptor halogens. The average error in acidity is within the experimental uncertainty of the data. Systematic errors have been found for the substituents which form internal hydrogen bondings. A reaso...
متن کامل129Xe NMR chemical shift in Xe@C60 calculated at experimental conditions: Essential role of the relativity, dynamics, and explicit solvent
The isotropic (129)Xe nuclear magnetic resonance (NMR) chemical shift (CS) in Xe@C60 dissolved in liquid benzene was calculated by piecewise approximation to faithfully simulate the experimental conditions and to evaluate the role of different physical factors influencing the (129)Xe NMR CS. The (129)Xe shielding constant was obtained by averaging the (129)Xe nuclear magnetic shieldings calcula...
متن کاملPhase Shift Oscillator Circuit Using Op-amp
The conventional sine wave oscillator circuits use phase shifting techniques that RC phase shift oscillator using op-amp in inverting amplifier introduces. Figure show a RC phase shift oscillator using Op-Amp with gain 5(Vo/Vi). My assumption : Circuit is generating a sine wave with a peak to peak voltage of 10v. Voltage stability, specifically the lack of, when using a resister divider is the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review B
سال: 2001
ISSN: 0163-1829,1095-3795
DOI: 10.1103/physrevb.63.134113