Electron Irradiation Induced Phase Transformation in Fe-Nd-B Alloys
نویسندگان
چکیده
منابع مشابه
Irradiation-induced patterning in dilute Cu–Fe alloys
Article history: Received 9 January 2014 Accepted 24 June 2014 Available online 1 July 2014 Compositional patterning in dilute Cu1 xFex (x 12%) induced by 1.8 MeV Kr irradiation was studied as a function of temperature using atom probe tomography. Irradiation near room temperature led to homogenization of the sample, whereas irradiation at 300 C and above led to precipitation and macroscopic co...
متن کاملtransformation in metastable Fe - Mn alloys
Metastable Fe-Mn alloys exhibit a non-thermoelastic martensitic transformation which is accompanied by a significant thermal effect (ca. 20 J/g). Among Fe-Mn alloys, the highest value of latent heat was registered in alloys with 17-18 wt. % Mn. In this work we investigate effects of carbon (up to 0.4 wt. %) and cold rolling (5-25% of thickness reduction) on the latent heat and the temperature h...
متن کاملRadiation-Induced Demagnetization of Nd-Fe-B Permanent Magnets
Introduction The Advanced Photon Source (APS), as well as other third-generation synchrotron light sources, uses permanent magnets in the insertion devices to produce x-rays for scientific research [1,2]. When placed in a high-energy storage ring, these permanent magnets are subjected to irradiation from synchrotron radiation, high-energy bremsstrahlung, and bremsstrahlung-produced neutrons. Pr...
متن کاملStress-induced FCC/FCT phase transformation in Fe–Pd alloy
We report stress-induced martensitic transformation in tensile loaded Fe–30.5 at.% Pd polycrystals, mainly using optical microscopy. Reverse transformation occurs during unloading. Thermodynamic relationships between applied stress, transformation strain and the latent heat of transformation are examined. 2002 Acta Materialia Inc. Published by Elsevier Science Ltd. All rights reserved.
متن کاملMartensitic Transformation in Microcrystalline Melt-Quenched Fe-Ni Alloys
The features of martensite transformation in Fe (31 32)% Ni melt-quenched alloys are considered. The meltquenching was realized by spinning technique with variable parameters. The influence of the melt-quenching on structural and kinetics transformation parameters is revealed. In particular Ms point is shown to decrease but volume percentage of athermal martensite is found to be invariable with...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2007
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.mj200702