Electron beam generation by electron multiplication
نویسندگان
چکیده
منابع مشابه
Electron Beam Generation in Tevatron Electron Lenses
New type of high perveance electron guns with convex cathode has been developed. Three guns described in this article are built to provide transverse electron current density distributions needed for Electron Lenses for beam-beam compensation in the Tevatron collider. The current distribution can be controlled either by the gun geometry or by voltage on a special control electrode located near ...
متن کاملA Reflex Electron Beam Discharge as a Plasma Source for Electron Beam Generation
A reflex electron beam glow discharge has been used as a plasma source for the generation of broad-area electron beams. An electron current of 120 A ( 12 A/cm2) was extracted from the plasma in 10 ps pulses and accelerated to energies greater than 1 keV in the gap between two grids. The scaling of the scheme for the generation of multikiloamp high-energy electron beams is discussed. E HAVE demo...
متن کاملMeasurements of Photon Beam Flattening Filter Using an Anisotropic Analytical Algorithm and Electron Beam Employing Electron Monte Carlo
Introduction: This study aimed to report the measurement of photon and electron beams to configure the Analytical Anisotropic Algorithm and Electron Monte Carlo used in clinical treatment. Material and Methods: All measurements were performed in a large water phantom using a 3-dimensional scanning system (PTW, Germany). ...
متن کاملBand-Gap Tuning Of Electron Beam Evaporated Cds Thin Films
The effect of evaporation rate on structural, morphological and optical properties of electron beam evaporated CdS thin films have been investigated. CdS thin film deposited by electron beam evaporation method in 12nm/min and 60nm/min evaporation rates on glass substrates. X-ray diffraction, scanning electron microscopy, UV-Vis-NIR spectroscopy and Atomic Force Microscopy were used to character...
متن کاملOptimization of Process Parameters of Electron Beam Welded Fe49Co2V Alloys
Electron beam welding has shown a remarkable job in the space industry for welding of components. It is performed under a vacuum environment that eliminates foreign matter such as hydrogen, oxygen, and other gases. Joining of similar and dissimilar materials is the main advantage of electron beam welding with high depth to width ratio as well as sharp focus at the point where parts are to be we...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Physics Letters
سال: 1989
ISSN: 0003-6951,1077-3118
DOI: 10.1063/1.101109