Electron beam extraction from bucket type plasma source.
نویسندگان
چکیده
منابع مشابه
A Reflex Electron Beam Discharge as a Plasma Source for Electron Beam Generation
A reflex electron beam glow discharge has been used as a plasma source for the generation of broad-area electron beams. An electron current of 120 A ( 12 A/cm2) was extracted from the plasma in 10 ps pulses and accelerated to energies greater than 1 keV in the gap between two grids. The scaling of the scheme for the generation of multikiloamp high-energy electron beams is discussed. E HAVE demo...
متن کاملLow-Energy Plasma Focus Device as an Electron Beam Source
A low-energy plasma focus device was used as an electron beam source. A technique was developed to simultaneously measure the electron beam intensity and energy. The system was operated in Argon filling at an optimum pressure of 1.7 mbar. A Faraday cup was used together with an array of filtered PIN diodes. The beam-target X-rays were registered through X-ray spectrometry. Copper and lead line ...
متن کاملAnalysis of Beam Quality Optimization of Bucket Ion Source
The bucket ion source is widely used as the high energy beam source on the high power neutral beam injector system. A hot cathode bucket ion source is studied. The main parameters which influence the performance of bucket ion source are arc voltage, filament voltage, gas inlet rate and extracted voltage. The proton ratio is the dominate parameter for the ion source. In the experiment, the chara...
متن کاملElectron-beam extraction system for the Frankfurt 14 GHz electron cyclotron resonance ion source
A new concept to assist in the extraction of ion beams from an electron cyclotron resonance ion source ~ECRIS! by the injection of an electron beam from the extraction side into the ion-source plasma is proposed. In this article, the construction of a test setup is described and first results of experiments with this setup at the 14 GHz ECRIS of the Frankfurt ECRIS-~ve!RFQ facility are reported...
متن کاملKinetic Plasma Simulation of Ion Beam Extraction from an Ecr Ion Source
Designing optimized ECR ion beam sources can be streamlined by the accurate simulation of beam optical properties in order to predict ion extraction behavior. The complexity of these models, however, can make PICbased simulations time-consuming. In this paper, we first describe a simple kinetic plasma finite element simulation of extraction of a proton beam from a permanent magnet hexapole elec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SHINKU
سال: 1988
ISSN: 0559-8516,1880-9413
DOI: 10.3131/jvsj.31.452