Electromagnetic Piercing of Aluminum Sheet Using Flat-Plate One-Turn Coil
نویسندگان
چکیده
منابع مشابه
SHEET ELECTROMAGNETIC FORMING USING CONVEX PUNCH INSTEAD OF CONVAVE DIE
High speed and absence of a precise control over pressure distribution confine sheet Electromagnetic Forming into a die to simple shapes having shallow depth. It is possible to reach a higher depth by using a convex punch instead of a concave die. In this study, sheet Electromagnetic Forming on a punch and sheet Electromagnetic Forming into a die are investigated. The electromagnetic part of th...
متن کاملCalculation of Stray Capacitances of MCG Coil include One Turn, Single-Layer and Conductor Wire Filaments in Rectangular form
This paper presents a new method called vespiary regular hexagonal (VRH) model in order to calculate parasitic capacitance between conductor wire filaments of one turn of coil (OTC) and between conductor wire filaments and liner and also total capacitance of one turn of the helix magneto flux cumulative generator (MCG) coil include single-layer conductor wire filaments in form of rectangular cr...
متن کاملVortex Sheet Roll-up Due to the Motion of a Flat Plate
The vortex-blob method is extended to compute vortex sheet separation at a sharp edge. A smoothing parameter con trols the amount of detail occuring in the rolled-up spiral. Cal culations are presented for the case of vortex sheet roll-up due to an impulsively started flat plate.
متن کاملDeflection of an elliptically loaded vortex sheet by a flat plate
We investigate the behavior of vortex flows in the presence of obstacles using numerical simulations. Specifically, we simulate the evolution of an elliptically loaded vortex sheet in the presence of a stationary flat plate in its path. The plate is represented by a number of point vortices whose strength is such that they cancel the normal fluid velocity on the plate. The sheet is approximated...
متن کاملPrediction of earing in deep drawing of anisotropic aluminum alloy sheet using BBC2003 yield criterion
This paper investigates the earing phenomenon in deep drawing of AA3105 aluminum alloy, experimentally and numerically. Earing defect is mainly attributed to the plastic anisotropy of sheet metal. In order to control such defect, predicting the evolution of ears in sheet metal forming analyses becomes indispensable. In this regard, the present study implements the advanced yield criterion BBC20...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Technology of Plasticity
سال: 2018
ISSN: 0038-1586,1882-0166
DOI: 10.9773/sosei.59.59