Electromagnetic Assessment of UHF-RFID Devices in Healthcare Environment

نویسندگان

چکیده

In this work, the evaluation of electromagnetic effect Ultra High Frequency Radio Identification (UHF-RFID) passive tags used in healthcare environment is presented. order to evaluate exposure levels caused by EM field (865–868 MHz) UHF-RFID readers, measurements an anechoic chamber and a real medical (Hospital Universitario de Canarias), as well simulations 3D Ray Launching algorithm, biophysical effects human models are The results obtained show that localized, close vicinity RFID reader inversely proportional its reading range. detected sufficient cause immunity electronic devices (malfunctions equipment or implants). Moreover, more than negligible direct humans (exceeding relevant SAR values) were found only next reader, up approximately 30% As consequence, risk could be firstly evaluated based on parameters, but should include situ assessment. It requires attention additional studies, increased applications monitoring systems observed sector—specifically when any system located workplace permanently occupied.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Electromagnetic Modelling of UHF RFID Tags*

Paper presents a method for analysis of UHF RFID tags. After a brief overview of RFID system and UHF tags an electromagnetic (EM) simulation of tags in WIPL-D software was conducted. Electrical matching was performed after which tags were excited by a uniform EM wave, induced powers were measured and tag characteristics were compared.

متن کامل

Passive UHF RFID Tag for Multispectral Assessment

This work presents the design, fabrication, and characterization of a passive printed radiofrequency identification tag in the ultra-high-frequency band with multiple optical sensing capabilities. This tag includes five photodiodes to cover a wide spectral range from near-infrared to visible and ultraviolet spectral regions. The tag antenna and circuit connections have been screen-printed on a ...

متن کامل

UHF RFID Reader Antenna

This chapter addresses the various design issues, requirements, and specifications in designing reader antennas for UHF RFID applications. In a typical UHF system, the RFID reader antennas are geography specific; that is, there are different antennas for different geography, namely North America, Europe, et cetera. The discussion on the design challenges and performance expectations lead to a n...

متن کامل

Effects of Interferences in Uhf Rfid Systems

The Radio Frequency Identification (RFID) applications are growing rapidly, especially in the UHF frequency band that is being used in inventory management. Passive UHF tags are preferred for these applications. In this paper, RFID reader-to-reader interference is analyzed. A model to estimate the minimum distance between readers to achieve a desired probability of detection in real multipath e...

متن کامل

Interference Analysis of Uhf Rfid Systems

In this paper, RFID reader-to-reader interference is analyzed from the point of view of interrogation range. To evaluate RFID interference quantitatively, the new figure-of-merit, interrogation range reduction ratio (IRRR), is defined. In order to show the usefulness of IRRR, its value is calculated in various environments. Additionally, the calculated IRRR values are verified by measurements u...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Applied sciences

سال: 2022

ISSN: ['2076-3417']

DOI: https://doi.org/10.3390/app122010667