Electrochemical Study of Three Stainless Steel Alloys and Titanium Metal in Cola Soft Drinks
نویسندگان
چکیده
منابع مشابه
Vacuum Brazing of Zirconium-Based Alloy and 321 Stainless Steel Using Titanium Based Filler Metal
Both Zirconium-based alloys and 321stainless steel are widely used as engineering alloys due to their good mechanical properties. Conventional fusion welding techniques for Zr alloys and stainless steel are not feasible due to the formation of brittle intermetallic compounds such as (Zr3Fe, ZrFe2 and Zr2Fe) and corrosion cracking. Brazing is one of the most wide...
متن کاملBoronization and Carburization of Superplastic Stainless Steel and Titanium-Based Alloys
Bronization and carburization of fine-grain superplastic stainless steel is reviewed, and new experimental results for fine grain Ti88.5Al4.5V₃Fe₂Mo₂ are reported. In superplastic duplex stainless steel, the diffusion of carbon and boron is faster than in non-superplastic duplex stainless steel. Further, diffusion is activated by uniaxial compressive stress. Moreover, non-superplastic duplex st...
متن کاملElectrochemical Characterization of a Martensitic Stainless Steel
This paper focused on the characterization of electrochemical behavior of a martensitic stainless steel in the acidic solutions. For this purpose, electrochemical parameters were derived from potentiodynamic polarization, Mott Schottky analysis and electrochemical impedance spectroscopy (EIS) techniques. The potentiodynamic polarization results showed that corrosion current density of AISI 420 ...
متن کاملElectrochemical deprotonation of phosphate on stainless steel
Voltammetric experiments performed in phosphate buffer at constant pH 8.0 on platinum and stainless steel revealed clear reduction currents, which were correlated to the concentrations of phosphate. On the basis of the reactions proposed previously, a model was elaborated, assuming that both H2PO4 and HPO4 2 underwent cathodic deprotonation, and including the acid–base equilibriums. A kinetic m...
متن کاملStructural Analysis of Three-metal Explosion Joint: Zirconium-titanium-steel
Explosion metal welding is high-speed angle oblique collision of two or more metal plates caused by detonation. The metal is joined – welded under high dynamic pressure creating by plastic deformation the waves on the bond interface, accompanied by local adiabatic heating 1 . The explosive metal cladding process can be divided into three stages: a) generation of explosion energy through the det...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electrochemical Science and Technology
سال: 2017
ISSN: 2093-8551,2288-9221
DOI: 10.33961/jecst.2017.8.4.294