Electroacoustic Transducer Calibration Combined with Semi‐Automatic Data Reduction
نویسندگان
چکیده
منابع مشابه
Transducers and Transducer Calibration
ed from: Figliola, R.S. and Beasley, D. S., 1991, “Theory and Design for Mechanical Measurements” GENERAL MEASUREMENT SYSTEM Assigning a specific value to a physical variable is done with the help of a measurement system. Once a value has been assigned to a physical variable it becomes known as a measured value. There are four stages to the process of assigning a value to a physical variable. G...
متن کاملChoosing Designs of Calibration Transducer Electronic Data Sheets
The IEEE 1451.2 standard for interfaces to networkable smart sensors and actuators introduced the notion of a calibration Transducer Electronic Data Sheet (TEDS), which contains the information needed by software for mapping between transducer-side values and physical unit values. When a calibration TEDS entry is created for a transducer, a calibration model (the degree of the multinomials and ...
متن کاملElectroacoustic calibration for sound field warble tone thresholds.
Walker, Dillon, and Byrne (1984) suggested reference equivalent threshold sound pressure levels (RETSPLs) for warble tones with specific modulation parameter values audited from a test position at the critical distance in a semireverberant sound field. This study evaluated these RETSPLs in two typical audiometric rooms and with typically encountered FM tones. Thresholds were measured under earp...
متن کاملA Strain Gauge Torque Transducer Calibration Study
-This paper presents for the study of torque transducer (torque sensor) calibration built into a rotating shaft, in this case uses strain gauge, which was done with, and the output signal of the "voltage (mV/V)" has been taken for each weight, increasing and decreasing the weights. The data have been taken three times which they have been divided into three series. First and foremost, the avera...
متن کاملReduction of Spectroscopic data: Spectrophotometric calibration of Gaia
The goal of this bachelorproject is to determine the absolute fluxes of stars for use as calibrators in the photometric reduction of data from the GAIA (Global Astrometric Interferometer for Astrophysics) astrometric satellite, which will fly in at the end of 2011.[1] This project involves observing candidate flux standard stars using the spectrograph on the Calar Alto 2.2m telescope in Sierra ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Acoustical Society of America
سال: 1960
ISSN: 0001-4966
DOI: 10.1121/1.1936366