Electrical Conductivity Measurements of Slag at Elevated Temperature -Properties of Slag at Elevated Temperature (Part II)-
نویسندگان
چکیده
منابع مشابه
Slag Behavior in Gasifiers. Part II: Constitutive Modeling of Slag
The viscosity of slag and the thermal conductivity of ash deposits are among two of the most important constitutive parameters that need to be studied. The accurate formulation or representations of the (transport) properties of coal present a special challenge of modeling efforts in computational fluid dynamics applications. Studies have indicated that slag viscosity must be within a certain r...
متن کاملViscoelastic Properties of Nafion at Elevated Temperature and Humidity
Tensile stress–strain and stress relaxation properties of 1100 equivalent weight Nafion have been measured from 23 to 120 C at 0–100% relative humidity. At room temperature, the elastic modulus of Nafion decreases with water activity. At 90 C, the elastic modulus goes through a maximum at a water activity of 0.3. At temperatures 90 C, hydrated membranes are stiffer than dry membranes. Stressrel...
متن کاملProperties of Low-alloy High-speed Steel at Elevated Temperature
J. Jaworski, T. Trzepieciński: Faculty of Mechanical Engineering and Aeronautics, Rzeszow University of Technology, Rzeszów, Poland This paper presents the results of research on the determination of the coefficient of thermal conductivity and hot hardness of cutters made of selected grades of low-alloy high-speed steels, HS 6-5-2 and HS3-1-2. The investigations of hot hardness and yield stress...
متن کاملLinear Collider Development at Slag
The status of the SLC has been described elsewhere in these proceedings.l$* This year’s noteable achievement is an increase of electron beam polarization at the IP from 23% to 63%. Also, luminosity is up from last year, and it is expected that this year’s goal of 50,000 Zs on SLD (Stanford Linear Detector) tape will be achieved. At the end of last year’s run, during E 400 .uncoupled damping rin...
متن کاملCharacterization of Austenitic Stainless Steels Deformed at Elevated Temperature
Highly alloyed austenitic stainless steels are promising candidates to replace more expensive nickel-based alloys within the energy-producing industry. The present study investigates the deformation mechanisms by microstructural characterization, mechanical properties and stress–strain response of three commercial austenitic stainless steels and two commercial nickel-based alloys using uniaxial...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Iron and Steel Institute of Japan
سال: 1969
ISSN: 0021-1583,1881-1183
DOI: 10.2355/isijinternational1966.9.39