Electrical Characteristics Cufe2o4 Thick Film Ceramics with Different Glass Concentrations Fired at 1000 °C for Negative Thermal Coefficient (Ntc) Thermistor

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Micro-PCR Chip NTC-Thermistor Sensor-Calibration System

In this paper, we implement a Steinhart-Hart calibration-factor value measurement system to obtain accurate temperature measurements of a negative-temperature coefficient thermistor. The thermistor is mounted on a micro-polymerase chain reaction (PCR) chip in a micro-PCR systemthat requires accurate temperature measurement and control. When obtaining the calibration-factor value, it is impossib...

متن کامل

Microwave Sintering of Thermistor Ceramics

Microwave sintering is a new sintering technology developed in the middle to late period of the 1980’s, which is characterized by fast densification for ceramic materials[1]. In recent years, microwave heating has been well employed in the field of sintering and joining of ceramics as a result of its advantages against conventional methods. These ceramic materials include oxides, mixed oxides, ...

متن کامل

Integrated thick-film nanostructures based on spinel ceramics

Integrated temperature-humidity-sensitive thick-film structures based on spinel-type semiconducting ceramics of different chemical compositions and magnesium aluminate ceramics were prepared and studied. It is shown that temperature-sensitive thick-film structures possess good electrophysical characteristics in the region from 298 to 358 K. The change of electrical resistance in integrated thic...

متن کامل

Nanostructured SnO2 thick films for gas sensor application: analysis of structural and electronic properties

This research is focused on structural and electrical characterisation of tin oxide (SnO2) applied as a thick film and investigation of its properties as gas sensitive material. Micron sized SnO2 powder was milled in an agate mill for six hours to fabricate SnO2 nanopowder, which was afterwards sieved by 325 mesh sieve and characterized by XRD and SEM. This powder was used as functional part in...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Materials Science Research

سال: 2012

ISSN: 1927-0593,1927-0585

DOI: 10.5539/jmsr.v1n3p70