Electric Field Optimization Using NURB Curve and Surface
نویسندگان
چکیده
منابع مشابه
From Digitized Data to NURB Surface Meshes
A common reverse engineering problem is to convert several hundred thousand points collected from the surface of an object via a digitizing process, into a coherent geometric model that is easily transferred to a CAD software such as a solid modeler for either design improvement or manufacturing and analysis. These data are very dense and makes data-set manipulation difficult and tedious. Many ...
متن کاملOptimization of pulsed electric field parameters for mango nectar processing using response surface methodology
Ready to Drink (RTD) mango nectar was subjected to pulsed electric fields (PEF) processing. The effect of process parameters including pulse frequency (70-120 Hz) and pulse width (1524 μs) on carotenes, total plate count, coliforms, yeast and moulds and over all acceptability was studied using a response surface methodology. Mango nectar exhibited high retention of carotene content at higher fr...
متن کاملNanoparticle Near-Surface Electric Field.
Theoretical studies show that surface reconstruction in some crystals involves splitting the surface atomic layer into two-upper and lower-sublayers consisting of atoms with only positive or only negative effective electric charges, respectively. In a macroscopic crystal with an almost infinite surface, the electric field induced by such a surface-dipole is practically totally concentrated betw...
متن کاملSurface Electric Field of Bare Strange Stars
The surface electric characteristics of bare strange stars are investigated with the inclusion of the boundary effect. The thickness of the electron layer where pairs can be spontaneously created is calculated as a function of the bag parameters. We find that previous estimates are representative for bag parameters within rather wide range, and therefore our results favor the thermal radiation ...
متن کاملDetermination of end conditions for NURB surface interpolation
NURB (Non Uniform Rational B-spline) curves and surfaces are being used to solve curve and surface tting problems i.e. where a sequence (or an array) of points is given and then one can nd a NURB curve (or an surface) that interpolates to the given data. In general one has to provide additional information, called end conditions to solve the system of equations in the NURB interpolation problem...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Power and Energy
سال: 1993
ISSN: 0385-4213,1348-8147
DOI: 10.1541/ieejpes1990.113.10_1081