Elasto/plastic strain concentration at a circular hole embedded in an anisotropic sheet
نویسندگان
چکیده
منابع مشابه
Bending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition
The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...
متن کاملSimple Shear of a Strain-hardening Elastoplastic Hollow Circular Cylinder
Stress and deformation analysis of the simple shear at finite strain of a strainhardening elastoplastic hollow circular cylinder is given. Both isotropic and anisotropic hardening models are considered. In the case of isotropic hardening, there is a closed form analytical solution. No normal stresses exist in this case. Purely kinematic hardening with a Mises-type yield condition is utilized as...
متن کاملBending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition
The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...
متن کاملStress concentration in a circular hole in composite plate
A non-contact measurement method, namely electronic speckle pattern interferometer (ESPI), was used to investigate the tensile strain field of a composites plate in the presence of stress concentrations caused by a geometrical defect consisting of circular hole. ESPI uses the principle of 3D speckle interferometry to measure the deformation and contour of the measuring field with submicrometer ...
متن کاملFree-boundary dynamics in elastoplastic amorphous solids: the circular hole problem.
We develop an athermal shear-transformation-zone (STZ) theory of plastic deformation in spatially inhomogeneous, amorphous solids. Our ultimate goal is to describe the dynamics of the boundaries of voids or cracks in such systems when they are subjected to remote, time-dependent tractions. The theory is illustrated here for the case of a circular hole in an infinite two-dimensional plate, a hig...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Quarterly of Applied Mathematics
سال: 1989
ISSN: 0033-569X,1552-4485
DOI: 10.1090/qam/1012264