Elastodynamic Problem of an Interface Linear Crack under Harmonic Loading
نویسندگان
چکیده
منابع مشابه
The Interface Crack Problem Foranisotropic
The two-dimensional interface crack problem is investigated for ani-sotropic bodies in the Comninou formulation. It is established that, as in the isotropic case, properly incorporating contact zones at the crack tips avoids contradictions connected with the oscillating asymptotic behaviour of physical and mechanical characteristics leading to the overlapping of material. Applying the special i...
متن کاملPrediction of Crack Initiation Direction for Inclined Crack Under Biaxial Loading by Finite Element Method
This paper presents a simple method based on strain energy density criterion to study the crack initiation angle by finite element method under biaxial loading condition. The crack surface relative displacement method is used to eliminate the calculation of the stress intensity factors which are normally required. The analysis is performed using higher order four node quadrilateral element. The...
متن کاملPartial crack closure under block loading
Fatigue crack propagation tests under high–low and low–high block loading sequences have been performed in aluminium alloy specimens. The tests were carried out at constant DK conditions. Two stress ratios were analysed: R = 0.05 and R = 0.4. Crack closure was monitored in all tests by the compliance technique using a pin microgauge. The observed transient post load step behaviour is discussed ...
متن کاملModelling Mode I Crack Initiation in Composites under Fatigue Loading Using Interface Elements
Modelling quasi-static crack growth with interface elements is a widely accepted technique [1-2]. Interface elements are inserted into the finite element mesh along possible crack paths. The interface elements are characterised by a traction-displacement curve. When a specific maximum stress is reached, the interface element undergoes a softening process until the critical fracture energy has b...
متن کاملCrack Growth and Lifetime of Concrete under Long Time Loading
Edge-notched eccentrically compressed fracture specimens made of aggregate of reduced size are loaded in standard creep test frames. Measurements of the time rate of crack mouth opening in notched concrete specimens subjected to constant load of almost one month duration are reported and analyzed. To reveal the size effect, geometrically similar specimens of four sizes in the ratio I :2:4:8 are...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: PAMM
سال: 2008
ISSN: 1617-7061,1617-7061
DOI: 10.1002/pamm.200810229