Elasto-Plastic Finite Element Analysis of Imperfect Short Cylinders under Axial Compression

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Finite Element Study of Elasto-plastic Hemispherical Contact

This work presents a finite element study of elasto-plastic hemispherical contact. The results are normalized such that they are valid for macro contacts (e.g., rolling element bearings) and micro contacts (e.g., asperity contact). The material is modeled as elastic-perfectly plastic. The numerical results are compared to other existing models of spherical contact, including the fully plastic c...

متن کامل

Dislocation-Based Finite Element Modelling of Elasto-plastic Material Deformation

of the Thesis Dislocation-Based Finite Element Modelling of Elasto-plastic Material Deformation

متن کامل

Numerical Analysis of Piles in Elasto-plastic Soils under Axial Loading

A finite element model has been developed to simulate nonlinear response of piles/drilled piers under axial loading. The nonlinear stress-strain behaviors of soils are modeled via Drucker-Prager and von Mises type plasticity. A parametric study is carried out to address the influence of various factors, such as soil friction approximation, dilatancy, effect of interface element and shear streng...

متن کامل

Elasto-Plastic Finite Element Evaluation of Flexible Pavements Based on Shakedown Concept

In this paper, three-dimensional elasto-plastic finite element analysis was performed on flexible pavements under vertical repeated traffic loads to evaluate their shakedown behavior. Six different pavements with different structural number (SN) were modeled and subjected to a wide range of cyclic vehicle loads. Shakedown limits were obtained considering both failure and serviceability restrain...

متن کامل

Finite element analysis of elastic-plastic solids under Vickers indentation: surface deformation

Finite element modeling has been used to study the development of surface deformation during indentation with a Vickers indenter. A wide range of materials with different elastic modulus and yield stresses are examined. Results show that in a pyramidal indentation process, for a perfectly plastic material, sinking-in during loading can change to pile-up in unloading. This phenomenon depends on ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Society of Naval Architects of Japan

سال: 1983

ISSN: 1884-2070,0514-8499

DOI: 10.2534/jjasnaoe1968.1983.218