Elaboration of nanostructured polyurethane foams/OMMT using a twin-screw extruder in counter-rotating mode

Continuous Granulation with a Twin-Screw Extruder

Modeling of Transport Phenomena and Melting Kinetics of Starch in a Co-Rotating Twin-Screw Extruder

A mathematical model was developed to simulate fluid flow, heat transfer, and melting kinetics of starch in a co-rotating intermeshing twin-screw extruder (TSE). The partial differential equations governing the transport phenomena of the biomaterial in the extruder were solved by a finite element scheme. For validating the model, the predicted product pressure, bulk temperature at the entrance ...

Simulation of Distributive and Dispersive Mixing in a Co-rotating Twin-screw Extruder

Simulation results for mixing of two different polymers in a co-rotating twin-screw extruder are presented. Velocity distribution predicted by a threedimensional simulation of the flow is used to predict the change in the spatial distribution of initially segregated particles as well as the reduction in radius due to erosion. The predicted particle distribution is used to estimate the increase ...

evolution of co-continuous morphology along the screw length in a co-rotating twin-screw extruder and its effect on impact strength of compatibilized pa6/abs blend

an ultra-glide twin screw extruder is employed to allow the quick and easy removal of the screws from the fixed processing section within few seconds, probing the current degree of the melting state, the dispersive anddistributive processing steps and finally the level of morphology development along extruder screws. for morphological studies the molten samples, collected from different points ...

Non-isothermal Simulation of the Flow in Co-rotating and Counter-rotating Twin-screw Extruders Using Mesh Partitioing Technique

A new algorithm for simulation of non-isothermal flow in a twin-screw extruder is introduced. In the new algorithm, the finite element mesh of tetrahedral elements is created in the complete barrel including the space occupied by the screws. By partitioning the tetrahedral elements which are intersected by the screw surfaces into two tetrahedral, pyramidal or prismatic finite elements, the new ...