Eigenmode-Based Capacitance Calculations With Applications in Passivation Layer Design
نویسندگان
چکیده
منابع مشابه
Variable Capacitance Accelerometers: Design and Applications
All variable capacitance accelerometers have certain basic design elements in common. They incorporate a seismic mass whose motion in response to shock or vibration lags behind that of the accelerometer housing. The capacitor consists of two plates, one attached to the outer frame and therefore stationary and the other attached to the seismic, or inertial, mass. The value of this capacitor is a...
متن کاملElectrical Capacitance Volume Tomography: Design and Applications
This article reports recent advances and progress in the field of electrical capacitance volume tomography (ECVT). ECVT, developed from the two-dimensional electrical capacitance tomography (ECT), is a promising non-intrusive imaging technology that can provide real-time three-dimensional images of the sensing domain. Images are reconstructed from capacitance measurements acquired by electrodes...
متن کاملEigenmode Analysis of Eddy Currents and Eigenmode Coil Design
Introduction Eddy currents have long been the bane of MRI. Particularly since the mid 1980s when imaging sequences became more rapid [1] and superconducting magnets became routinely used. When gradient coils are switched rapidly, eddy currents are induced in the cryostat vessel and other surrounding conducting structures. Two principal solutions have been adopted into standard practice for deal...
متن کاملInformation Criteria and Higher Eigenmode Estimation in Monte Carlo Calculations
Recently developed Monte Carlo methods of estimating the dominance ratio (DR) rely on autoregressive (AR) fittings of a computed time series. This time series is obtained by applying a projection vector to the fission source distribution of the problem. The AR fitting order necessary to accurately extract the mode corresponding to DR is dependent on the number of fission source bins used. This ...
متن کاملChaos-Based Physical Layer Design for WSN Applications
Due to their correlation properties, chaotic sequences can be used in direct sequence spread spectrum systems. In this paper the application of these sequences for design of physical layer in wireless sensor networks is presented. In order to mitigate fading the chip interleaving technique is investigated. Theoretical expressions in closed form for the bit error rate (BER) are derived and confi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Components, Packaging and Manufacturing Technology
سال: 2011
ISSN: 2156-3950,2156-3985
DOI: 10.1109/tcpmt.2011.2125789