Efficient Non-Linear 3D Electrical Tomography and Finite Element Optimizations for Functional Source Imaging
نویسندگان
چکیده
منابع مشابه
Non Linear Finite Element Analysis of Reinforced and Unreinforeced Pavements
In this research a comprehensive finite element program was developed in order to carry out an elasto perfectly plastic analysis of geogrid reinforcement of a model pavement. Qualitative agreement is seen between the numerical results and experiment. The results indicate the influence of geogrid in reduction of vertical deformation of pavements. It is also seen that for strong subgrade, the opt...
متن کاملA High-order Finite Element Method for Electrical Impedance Tomography
Electrical impedance tomography (EIT) is a non-invasive imaging technique where a conductivity distribution in a domain is reconstructed from boundary voltage measurements. The voltage data are generated by injecting currents into the domain. This is an ill-conditioned non-linear inverse problem. Small measurement or forward modeling errors can lead to unbounded fluctuations in the reconstructi...
متن کاملBreast imaging using 3D electrical impedence tomography.
AIM To determine the diagnostic efficiency of 3D Eletrical Impedance Tomography (EIT) compared to Mammography (MG) and Ultrasonography (USG) in imaging the breast. MATERIALS AND METHODS A group of 88 patients presenting with various breast complaints was examined using combined Mammography and Ultrasonography (MG & USG) or either of these modalities alone. The same patients were then examined...
متن کاملA finite-element-based reconstruction method for 3D fluorescence tomography.
In this paper, we propose a dual-excitation-mode methodology for three-dimensional (3D) fluorescence molecular tomography (FMT). For this modality, an effective reconstruction algorithm is developed to reconstruct fluorescent yield and lifetime using finite element techniques. In the steady state mode, a direct linear relationship is established between measured optical data on the body surface...
متن کامل3D Finite Element Meshing from Imaging Data.
This paper describes an algorithm to extract adaptive and quality 3D meshes directly from volumetric imaging data. The extracted tetrahedral and hexahedral meshes are extensively used in the Finite Element Method (FEM). A top-down octree subdivision coupled with the dual contouring method is used to rapidly extract adaptive 3D finite element meshes with correct topology from volumetric imaging ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Biomedizinische Technik/Biomedical Engineering
سال: 2001
ISSN: 0013-5585,1862-278X
DOI: 10.1515/bmte.2001.46.s2.130