Effects of Vacuum-Stirring Purification Process on Al-6Mg Alloy Melt
نویسندگان
چکیده
Aiming for hydrogen and oxidation easily produced in the melting process of Al-Mg alloys, three processes, including non-vacuum static melt treatment, rotary-injection purification vacuum-stirring purification, were used to purify Al-6Mg alloy melt. The content inclusion studied by means solid-state measurement method, reduced pressure test FESEM EDS. results show that effect is better than treatment purification. decreases from 0.48 mL/100 gAl 0.32 0.10 process. 2.6% 0.69% process, 0.39%,
منابع مشابه
The Effects of Gating Systems on the Soundness of Lost Foam Casting (LFC) Process of Al-Si Alloy (A.413.0)
The effects of gating systems, number of runner, and their locations, in the Lost Foam Casting (LFC) of Aluminum alloy (A.413.0) were investigated. Six different gating systems, with one or two running systems were designed. X-ray radiography and the three axis-bending tests have been employed to evaluate the casting soundness and quality. The results revealed that gating systems have a major e...
متن کاملEFFECTS OF A MODIFIED SIMA PROCESS ON THE STRUCTURE, HARDNESS AND MECHANICAL PROPERTIES OF Al-12Zn-3Mg-2.5Cu ALLOY
A modified strain-induced melt activation (SIMA) process was applied and its effect on the structural characteristics and hardness of the aluminum alloy Al–12Zn–3Mg–2.5Cu was investigated. Specimens subjected to a deformation of 40% at 300 °C were heat treated at various times (10-40 min) and temperatures (550-600 °C). Microstructural studies were carried out using opt...
متن کاملInfluence of Homogenization on Mechanical Properties of Al-1Mn-1Mg Alloy Prepared by Different Melt-Treatments
Influence of homogenization on mechanical properties of Al-1Mn-1Mg alloy prepared by different melttreatments was discussed and mechanism of metallurgical defects on ingots’ mechanical properties was analyzed. It was found that metallurgical defects, such as the inclusions and gas holes, cannot be removed from the original ingots by homogenization; the average increasement of tensile strength o...
متن کاملHeat Transfer during Melt Spinning of Al-7%si Alloy on a Cu-be Wheel
Transient heat transfer models of the single-wheel meltspinning process are developed and applied to quantify the effect of process variables including interface depressions on solidification, temperature evolution, thickness variations, and surface depressions in the cast product. Firstly, a transient one-dimensional heat-transfer model of the melt-spinning process called STRIP1D was developed...
متن کاملThe Effect of Cross-Rolling Process on Nanostructure of Al 1050 Alloy
The cross-rolling is a new process that results in significant evolutions in microstructure of the metallic sheets. In this study, an aluminium 1050 sheet was rolled up to 95% reduction in cross directions for ten passes. The rolled samples were investigated by X-ray diffraction (XRD) and transmission electron microscopy (TEM). The rolled samples possess a high dislocation density and ultra-fin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Crystals
سال: 2022
ISSN: ['2073-4352']
DOI: https://doi.org/10.3390/cryst12050675